Placement of Rear Jacks in Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System
Question:
I have a 32foot rig that has a 6inch I-beam frame with the entrance door behind the real tires. Installation of the rear jacks would likely need to be 3foot or 4foot behind the rear tires rather than the 1foot indicated in the install instructions. As a result, knowing how far below the frame the retracted jack hangs below the frame is critical. I do see in description that the jack travel is 12.5 so Im assuming the top of the jack motor to the retracted jack pad must be at least a few inches more than the travel. Thanks
asked by: Scott K
Expert Reply:
For the rear jacks in Lippert Ground Control 3.0 # LC358590 the bracket the jacks attach to have multiple holes and you will need to mount them so that when fully retracted the jacks have 7 to 9 inches clearance from the bottom of the foot to the ground. Overall height when retracted is closer to 24 inches.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Video: Lippert Ground Control Electric Leveling System Installation - 2016 Keystone Sprinter Fifth Wheel
- Shop: Solera RV Awning Shade Screen - Zip-Off Front Panel - 15' Wide x 10' Tall - Black Mesh
- Search Results: lippert ground control
- Shop: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Q&A: How to Determine Middle Jack Placement of Lippert Ground Control 3.0
- Video: Lippert Ground Control Electric Leveling System Installation - 2015 Forest River Vengeance TT Toy Ha
- Search Results: ground control 3.0
- Shop: Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - Black
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Installing Middle Jacks of Lippert Ground Control Where They May Interfere with Slide Out
- Search Results: lippert 30
- Shop: Replacement 22-1/2" Left Rear Leg for Lippert Ground Control 3.0 Electric Leveling System
- Search Results: landing gear parts
- Search Results: scissor jack
- Shop: Buyers Products Weld-On Receiver Tube with 2" Hitch Receiver - 48" Long - 20K
- Shop: Snap Bushing Grommet - 9/16" ID, 11/16" OD
- Video: Lippert Ground Control Replacement Leg Review
- Search Results: disc brake conversion kit
- Video: Review of Lippert Components - Trailer Jack,Camper Jack - LC349975
- Shop: Suspension Enhancement
- Search Results: tire monitoring system
- Q&A: Solutions To Add More Clearance For Lippert Ground Control 3.0 Jack Legs
- Q&A: Install Manual for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System
- Video: Lippert Components Trailer Jack LC342610 Review
- Q&A: Can Rear Jacks of Lippert Ground Control be 24 inches From Rear Axle
- Q&A: How Do Rear Jacks of Lippert 6.0 Ground Control Fit with Slide Out Cross Shaft
- Shop: RV Jack Pads
- Video: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System Review
- Video: Pollak 50 Amp Metal Circuit Breaker Review