Availability of Trailer Grease Seal that would Fit Golf Cart
Question:
I need a replacement grease seal for a wheel on a golf cart trailer. Its the thinnest seal I have ever seen - about 5/32inch not over 3/16 thick. The inside and outside diameters look about like your part #10-9. On the rubber seal it has TCR imprinted. I can send a picture if desired.
asked by: Wayne P
0
Expert Reply:
The grease seal part # 10-9 that you referenced is designed for use on a trailer hub, but if the inner and outer diameters match what you golf cart has it could potentially work for you.
The inner diameter of the seal is 1.5 inches and the outside diameter is 1.987. If your seal matches that exactly it should work.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.500 Inch I.D.
- 1.987 Inch O.D
- TruRyde
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Can the Dutton-Lanison Drill Drive Socket Adapter Be Used to Raise/Lower the Roof On a Jayco Pop Up
- Q&A: How To Figure Out the Correct Replacement Hubs for EZ Loader Boat Trailer
- Q&A: Replacement Grease Seal 4410275 For Shoreland'r Boat Trailer
- Q&A: Cross Referencing 10-9 Replacement Grease Seals for Aliner Trailer
- Q&A: Where to Find The Axle Serial Number On Dexter Axles Manufactured After April 2001?
- Q&A: Replacment Motor for Pump Assembly on Lippert LCI Pump 650057
- Q&A: How To Determine Which Bearing Kit Is Correct For 1984 EZ Loader M522000 Boat Trailer