How to Install Circuit Protected Modulite Wiring Harness C59496 on a 2006 Mercury Montego
Question:
Do you have installation instructions and wiring diagrams for a 2006 Mercury Montego for this kit?
asked by: Paul H
Expert Reply:
The # C59496 hardwire kit is a universal application, so I have linked the installation instructions below, but they are not going to be specific to your 2006 Mercury Montego.
To install the hardwire kit on your vehicle, you would use the included circuit tester to test the wires behind your vehicle tail lights for function. I would have a friend sit at the wheel and press the brake pedal or engage the turn signals as you test each wire behind your tail light. Once you have determined which wire is performing which function, you would connect the wires from the converter accordingly.
The four basic wire functions for the wires coming from the black converter box would be:
Green: Right turn and brake lights.
Yellow: Left turn and brake lights.
Brown: Running lights.
White: Ground wire. Connect this wire to a good, clean metal area on your vehicle frame.
Red: If your vehicle uses the same wire for the brake lamps and the turn signals, you'll ground this wire along with the white wire. If your vehicle uses a separate wire to carry the brake lamps, tap the red wire into it.
You will also see a thicker red wire coming from the converter box. You would run this wire, using the included wire bundle, and connect it to the vehicle positive battery terminal, with the included yellow fuse holder in between.
Product Page this Question was Asked From
Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 8 Feet Long
- Universal Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Where to Position the Trailer Axle?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Total Length of Strap in Hollywood Racks Strap Extension Kit For Destination E-Bike Rack
- Q&A: Mounting the Aluminum A-Frame Trailer Tongue Toolbox to the A-Frame of The Trailer