Replacement Pins to Hold Ramp Brackets to MaxxTow Cargo Carrier MT70260
Question:
i purchased the MaxxTow Hitch Cargo Carrier - MT70260 and i have lost the 2 little pins that hold up the ramp with the brackets. how can i go about replacing these? Thanks!
asked by: Daniel
0
Expert Reply:
The small pin that holds the brackets to the ramp of the MaxxTow carrier # MT70260 should fit in a 5/16 inch diameter hole. We have 5/16 inch diameter snapper pin # 516-134TR that could work for you. It is a little longer than the regular pins on the carrier.
expert reply by:
Michael H
0
Product Page this Question was Asked From
- Hitch Pins and Clips
- Snapper Pin
- 1-3/4 Inch Long
- 5/16 Inch Diameter
- 1-3/4 Inch Span
- Redline
more information >
Continue Researching
- Q&A: Are Radial Tires Better than Bias-Ply Tires for a Boat Trailer
- Q&A: Determining Which Replacement Wheel Bearings Needed for SnowBear 8000 Utility Trailer
- Q&A: Lift Kit for 2017 Lance 2285 with Tandem Dexter Number 10 Torflex Axles
- Q&A: Would the Replacement Square End Cap 853-5826 Fit Gorilla Lift GL1
- Q&A: How Much Can I Tow With the Anti-Wobble Device with Lock # 63232 and a 10,000 Lbs. Hitch
- Q&A: Is There Left Hand Side Version of Paneloc Spring Latch part # F785-104Z
- Q&A: Recommended Replacement for 4-Leaf 32" Long Trailer Slipper Springs