Replacement Handle Latch for Cam-Door Lock on 2006 Interstate Load Runner
Question:
I have a 2006 Interstate Load Runner. The handle latch is damaged. The length of the whole door lock is 45. The latch measures 4 3/4inch from center of the two closest wholes, and it is 1 1/4inch wide. I would like to know if you have a latch that will fit?
asked by: Kent H
Expert Reply:
I checked the Interstate Trailer website for details on the cam door locks they used on your 2006 Load Runner but no specifics are provided. However, I did check their replacement parts to see what they offer and we do have a replacement cam lock hasp (handle catch) that is quite similar to theirs, our part number # 158-101 that you referenced. The mounting hole centers are 4-1/4-inches apart on center and it accepts a 1-1/4-inch wide handle.
We also have part # 158-102. This hasp has mounting holes spaced 4-inches apart on center and will also accept a handle that is 1-1/4-inches wide like yours.
Products Referenced in This Question
Replacement Hasp for Polar Cam-Action Latch Kit - 2" Wide - Zinc-Plated Steel
- Trailer Door Latch
- Hasps
- 2-Hole Hasp
- Steel
- Lock Not Included
- 5-1/8 Inch Long
- 4 Inch Hole Spacing
- 2 Inch Wide
- Polar Hardware
more information >
Product Page this Question was Asked From
Replacement Hasp for Polar Cam-Action Latch Kits - 1" Wide - Zinc-Plated Steel
- Trailer Door Latch
- Hasps
- 2-Hole Hasp
- Steel
- Lock Not Included
- 5-1/8 Inch Long
- 4-1/4 Inch Hole Spacing
- 1 Inch Wide
- Polar Hardware
more information >
Continue Researching
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Article: How to Replace or Install an RV Roof Vent
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Bearing Kit for Horse Trailer with Bearing ID of 1.25 1.75 and Seal 2.25 inch
- Article: Trailer Tire Sizing
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices