2014 Dodge Ram Front Hitch Skid Plate Interference

Question

Question:

I have a 2014 Dodge Ran Outdoorsman. Will the front skid plate interfere with the install of the front hitch either brand, Drawtite or the Curt

asked by: Michael W

0

Expert Reply:

There are no skid plate fit notes for the front mount hitches for your 2014 Ram 1500. That would lead me to believe that the skid plate of your truck is aftermarket. Which the best recommendation I can make would be for you to check out the install instructions and picture I attached to see how this hitch installs and compare them to your truck to see if the skid plate would interfere.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The install of the Curt Hitch #31374 and the Draw Tite hitch part #65062 on your 2015 Ram 1500 are going to be so similar that you really wouldn't gain much in terms of fascia trimming/modification if you went with one or the other. The Curt…

view full answer...

Answer 2

The distance from the bottom of the sub frame, which is the same as the top of that bracket, to the bottom of the receiver on the #31374 is 6-7/8".

view full answer...

Answer 3

The Curt Front Hitch #31374 that you referenced does fit your 2021 Ram 1500 Classic and would require you to remove the tow hooks.

view full answer...

Answer 4

Curt has the front hitch part #31374 as a fit for your 2016 Ram 1500 Limited with no fit exclusions for if the vehicle has air ride suspension. The same goes for the Draw Tite #65062 that you mentioned. Since you want as hidden of a hitch as possible…

view full answer...

Answer 5

The Detail K2 Avalanche Elite Snowplow part #K2AVAL8422ELT will work with a front mount trailer hitch that is between 9" to 18" from the ground to the bottom inside edge of the receiver tube according to Detail K2. The blade height is…

view full answer...

Answer 6

We do offer front-mount hitches for your 2016 Ram 1500 4x4, two that are shown on the linked page, but neither one is a no-drill installation. Both require drilling and some fascia trimming (to make room for the receiver tube) and removal of the tow…

view full answer...

Answer 7

Yes, the factory tow hooks of your 2018 Ram 1500 will need to be removed when installing the Curt Front Mount Trailer Hitch Receiver #31374.

view full answer...

Answer 8

As long as your 2015 Ram 1500 Big Horn is a 4x4 then the best option we have to help with front end sag due to the snow plow you have installed is the Timbren Front Suspension Enhancement System part #TDF15004B which is actually designed specifically…

view full answer...

Answer 9

I have included a picture that shows the measurements needed for a spindle, bearings, seals, faces, and hubs. The spindle measurements are labeled A through F. A is the spindle shaft diameter B is where the grease seal sits C is where the inner…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 12

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

2014 Dodge Ram Front Hitch Skid Plate Interference

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching