Installing Brake Controller On 2006 Chevrolet Trailblazer
Question:
Hey I just received my p3 controller and you included a wire harness that has a brown end. Im assuming thats to plug into the vehicle nut not sure where the plug is at. All i have found are the 4 wires on the left taped to the large cluster. Lemme know if there is an actyal plug or do I just splice these wires? Thanks
asked by: Ryan B
Expert Reply:
There will be no port under the dash of your 2006 Chevrolet Trailblazer, but after removing the kick panel you will find a cluster of wires, with the wires you need identified with a piece of white tape or paper.
You will need to free those wires so the P3 # 90195 can be installed. The wires on the vehicle will not match color to color so you will need to attach them in the following manner. The black wire from the brake controller attaches to the orange wire on the vehicle. The blue wire on the brake controller matches up with the blue wire form the vehicle. The white wire from the controller gets attached to the black wire form the vehicle, and the red wire on the controller harness connects to the light blue wire on the vehicle.
I have attached a link to an installation video for a P3 controller on a Trailblazer you can check out. I have also attached some helpful articles you can take a look at.
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Parts Needed to Tow a Trailer with a 2015 Honda Pilot