Can the Brophy Steel Scissor Steps be Installed on a Truck Tailgate
Question:
Can these steps be mounted to a tailgate? Just plan to use them for ease of access into the truck bed. I see that the other models have a decent applicability for tailgate use just want to make sure this model uses the same mounting system.
asked by: Eric
Expert Reply:
Yes, you can mount the Brophy Steel Scissor Steps, # SS04, to a truck tailgate. I recommend installing the mounting bracket on the top of the tailgate (see photo). To install the mounting bracket, you will want to use four 1/4 inch x 1-1/2 inch long lag screws. Brophy recommends pre-drilling the holes with a 5/32 inch drill bit.
You may also be interested in the Non-Slip Adhesive Safety Strips, # NSAS.
Products Referenced in This Question
Non-Slip Adhesive Safety Strips, 1" x 11" (Qty 4)
- Accessories and Parts
- RV Steps
- Grip Tape
- 1 Inch Wide
- 11 Inch Long
- Brophy
more information >
Product Page this Question was Asked From
Brophy Camper Scissor Steps - 4 Steps - Steel - Diamond Tread - 17" Wide - 275 lbs
- RV Steps
- Truck Camper
- Snap-On Step
- 17 Inch Wide Step
- 18-1/4 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- Ground Contact
- Steel
- Brophy
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: step stools
- Video: Review of Yakima Reflective Decal - Y42KV
- Shop: Safety Step Folding Platform Step - Aluminum - 19" Long x 15" Wide - 1,000 lbs - Yellow
- Search Results: reflective tape
- Shop: Replacement Non-Slip Safety Strips for 19" x 15" Safety Step Platform Steps
- Shop: Replacement Red Reflective Yakima Decal for 2016 Yakima Products - 6-1/2" Wide x 1" Long
- Video: Race Ramps 24 Inch Trailer Step Review
- Video: Optronics Red and White Conspicuity Reflective Tape Review RE18T
- Search Results: foam blocks
- Video: Brophy RV and Camper Steps NSAS Review
- Shop: Non-Slip Adhesive Safety Strips, 1" x 11" (Qty 4)
- Shop: Race Ramps Trailer Step - 8" Lift - 35-1/2" Long - Qty 1
- Shop: Race Ramps Trailer Step - 11" Lift - 24" Long - Qty 1
- Shop: Race Ramps Trailer Step - 15-1/2" Lift - 24" Long - Qty 1
- Search Results: equalizer
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Search Results: dust caps
- Shop: Trailer Wiring
- Search Results: jack
- Shop: Brake Controller
- Shop: Fifth Wheel Hitch
- Shop: Base Plate for Tow Bar
- Shop: Suspension Enhancement
- Shop: Gooseneck Hitch
- Q&A: Replacement Inner Member Assembly for UFP A 60 Surge Brake Coupler
- Q&A: Replacement Fulton Winch Strap Measuring 1-7/8 Inches by 14 Feet Long
- Q&A: Do Free Backing Brake Assemblies Still Require Use of Manual Lock Out on Actuator
- Q&A: Replacement for Atwood 70254 RV Landing Gear Switch