Installation Instructions for Teknonsha Voyager # 39510 Using Factory Wiring Adapter
Question:
I need the wiring diagram for M/N 9035 when wired to a 2000 Ford F150 with factory installed wire harness. Thank You.
asked by: Marty D
Expert Reply:
I do not have a wiring diagram available, but I can certainly assist you with that installation. If you are using the Factory Supplied Wiring Harness (NOT an aftermarket model) the brake controller would wire to the harness as follows:
The red wire on the harness connects to the black wire on the brake controller, the light green wire on the harness connects to the red wire on the controller, the white wire on the harness connects to the white wire on the controller and the blue wire on the harness attaches to the blue wire on the controller. Your factory harness might also have a brown wire. This wire is for an illumination circuit that the controller does not use. Tape off the end of this wire and tuck it up out of the way.
If you are using and aftermarket wiring harness like the Brake Controller Wiring Adapter, part # 3035-P, you'd simply plug one end into the controller, the other end into the connector under the dash of your truck.
For your convenience, I will also link you to a copy of the operation instructions for the Tekonsha Voyager Brake Controller. I'll also link you to an install video.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Best Camper Jacks
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)