Can the Pre-Drilled Round Rubber Bumpers # D3-96 be Trimmed Down
Question:
My damaged one measures about 3inch x 3inch and 84inch in length, can the 3inch one you offer be trimmed down and still function? Thank you
asked by: Janis
0
Expert Reply:
Yes, the Pre-Drilled Round Rubber Bumpers # D3-96 that you referenced can easily be trimmed down to length so that it would fit your application.
After going out into the warehouse and looking at the bumper I would recommend either using a utility knife to very carefully cut it, or securing the rubber tightly and using a sawz-all to make the cut.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 3" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- 3 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Can I Charge My Trailer Battery Using 7-Way Trailer Connector on Truck
- Q&A: Size of Hole Saw to Use to Install the Recessed Trailer D-Ring Tie Down RR5K
- Q&A: Recommended Replacement Hub Assemblies for a Trailex Trailer with a 8 inch Wheel with 4 Bolts
- Q&A: Can RV Covers Be Left On Travel Trailer While Driving
- Q&A: What is Max Safe Tire Temperature
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Replacement Automotive Lighting
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)