Front Mount Receiver Hitch for a 2015 Ford F-150 with 5-1/2 Foot Bed

Question

Question:

Will this fit the Crew cab Model 2015 F150 5.5 bed?

asked by: Gary A

0

Expert Reply:

Draw-Tite front mount receiver # 65067 fits all models of the 2015 Ford F-150 including SuperCrew models. I have included a link to a the installation instructions for you.

expert reply by: Michael H

0

Answer 1

While the Draw-Tite Front Mount Trailer Hitch Receiver #65067 has not yet been confirmed to fit your 2023 Ford F-150, it is safe to say it will still fit as the only changes to the 2023 from 2022 is some trim level changes. I cannot say if the hitch…

view full answer...

Answer 2

I checked with Draw-Tite and the Draw-Tite Front Mount Trailer Hitch Receiver part #65067 is a confirmed fit for a 2023 Ford F-150, all models without an active air dam. This hitch features a bolt-on fit without any drilling required. It will be a…

view full answer...

Answer 3

The receiver on the Draw-Tite front mount hitch #65067 is plenty long enough for the shank of a dirt bike carrier. And it is open at the back so if there wasn't anything behind the hitch (which there will be since it is mounted on a vehicle!) a…

view full answer...

Answer 4

The Draw-Tite Front Mount Trailer Hitch Receiver #65067 will actually work with the auto deploying air dam on your 2022 Ford F-150, although there is some trimming of the air dam and the reinforcement bracket to get it installed (see attached photo…

view full answer...

Answer 5

The front hitch I recommend for your 2015 Ford F-150 Is the Draw-Tite Hitch, part #65067. This hitch can be used for hitch accessories like winches, spare tire carriers, or a snowplow. This has a 2 inch receiver opening and has a line pull capacity…

view full answer...

Answer 6

The Draw-Tite Front Mount hitch part #65067 installs so that it sticks out from the plastic air dam of the Ford. The hitch does not sit lower than the lowest part of the truck so it does not reduce ground clearance. I have attached a photo for your…

view full answer...

Answer 7

The Curt Front Mount Trailer Hitch Receiver #C31083 and Draw-Tite Front Mount Trailer Hitch Receiver #65067 are currently the only 2 front mount receivers that are custom fit for your 2015 Ford F-150 XLT. Both receiver have the same 9,000lb line pull…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Front Mount Receiver Hitch for a 2015 Ford F-150 with 5-1/2 Foot Bed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching