Trailer Brake Controller Recommendation for 2014 GMC Acadia SLT with Factory 7-Way Tow Package

Question

Question:

I have a 2014 gmc acadia with factory tow package. It came with the factory wiring harness for a brake control box. one end is the factory plug connection and the other end are bare wires to make a hard wire connection. 1. which brake control box on your website do you recommend. 2. I am having trouble locating where the connection for the wiring harness is under the driver side dash/kick panel. do you have a link to a picture/diagram?

asked by: Dale

0

Expert Reply:

Among the most popular and reliable trailer brake controllers we offer is the Tekonsha Prodigy P3, part # 90195. This proportional controller works with both electric and electric-over-hydraulic brakes and will ensure your trailer will stop in proportion to the tow vehicle, which saves wear and tear on the brakes of both vehicle and trailer.

If your Acadia has a factory tow package with 7-way trailer socket at the rear bumper you'll need to order just the controller itself and the matching quick-connect harness, part # 3026-P. I have linked for you a video showing installation of these components in a 2011 GMC Sierra. This will help you find the wiring.

If your truck does not have a factory 7-way socket at the rear bumper then instead you'll need to order the controller unit and our installation kit, part # ETBC7. This kit includes everything you need to convert the truck's 4-pole flat trailer wiring to a 7-way and to allow completion of the brake controller wiring. I have linked both a video and article on installing the ETBC7.

If you do not have a working 4-pole on the truck you'll need to install one. If needed you can use part # C56245 from Curt.

expert reply by: Adam R

0

Answer 1

The vehicle is indeed pre-wired, as you suspected. To get completely set up, you'll need a brake controller, the appropriate wiring harness to connect the controller to the vehicle and a trailer connector for the rear of the vehicle. All the rest…

view full answer...

Answer 2

An option is the Classic Accessories Deluxe PolyPro III Heavy-Duty Pop-Up Camper Cover - 18' - 20' Long #CA80043. This has a cover height of 42 inches as you mentioned, but it also has a width of 88 inches and is made to work well with AC…

view full answer...

Answer 3

GM states in the owner's manual that to recreationally tow the vehicle, the negative battery cable must be disconnected. The owner's manual doesn't list a specific reason, it only states that failure to do so could damage the vehicle. The…

view full answer...

Answer 4

When you say you have 2 batteries, I am assuming you may have a diesel model. Even if this is the case, you still only need one battery disconnect kit. This is because batteries are wired together on a single system. If you use the disconnect on one…

view full answer...

Answer 5

The storage cover that is the best fit for your Forest River Rockwood HW296 pop-up camper is from Adco, and is the following part number: - Adco SFS AquaShed RV Cover for Pop-Up Camper #290-12294 The AquaShed #290-12294 is for pop-ups with boxes…

view full answer...

Answer 6

What you need to do is check the hitch or owners manual on your vehicle. There will be towing capacities listed, and if you see a second set of towing capacities when using a weight distribution system that will tell you if you have the ability to A.…

view full answer...

Answer 7

Weight carrying is the gross trailer weight capacity of the hitch. Weight distribution is a device used to better distribute the tongue weight from a trailer to all axles of the tow vehicle and trailer. It produces more stress in certain places on…

view full answer...

Answer 8

For your 2008 GMC Acadia and 2006 Forest River Surveyor at 450 TW and 4,500 GTW, the Reese Round Bar Strait-Line Hitch with Shank, #66087, that you referenced would be a good system for this application. The Reese Round Bar Strait-Line Hitch with…

view full answer...

Answer 9

Your 2017 GMC Acadia Denali with the factory V92 towing package is rated to tow a trailer up to 4,000lbs. This information is directly out of the owners manual for your Acadia. I do recommend using a weight distribution hitch like the Fastway e2…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Trailer Brake Controller Recommendation for 2014 GMC Acadia SLT with Factory 7-Way Tow Package

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching