Installing Camco Automatic Changeover 2-Stage Propane Regulator on 2013 Rockwood RV

Question

Question:

How does one install the Camco Propane Double Stage Auto changeover regulator? Is it easy for a person who doesnt have much experience with propane tanks? The rv has 2 tanks.

asked by: Donna H

1

Helpful Expert Reply:

It is actually quite easy to install the Camco Automatic Changeover 2-Stage Propane Regulator for Dual Propane Tanks, part # CAM59005.

You will simply unscrew the old regulator from the sidewall. Then, using a wrench, remove the supply hose. You then disconnect the 2 pigtails connected to the propane tanks from the old regulator then reconnect the pigtails to the new regulator. Next hook up the supply hose, and remount the new regulator to the sidewall and you are good to go.

I have included a video demonstration of part # CAM59005, for you to check out.

expert reply by: Chris O

1

Answer 1

I recommend the Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM42RR for your 2016 Forest River Georgetown XL 378TS. This stabilizer uses a nitrogen-charged tandem gas spring which applies full force right when you need it…

view full answer...

Answer 2

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 3

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 4

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

From our experiences the Harbor Freight trailers like yours have a hub bore that requires a cap or Bearing Buddy that measures 2.047 inches like the #BB2047 you referenced. We don't have a standard cap that fits this size so the Bearing Buddy is…

view full answer...

Answer 10

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 11

For a standard replacement equalizer for your Dexter 13-122 equalizers you'd want the #TREQE1 or for a cushioned version you'd want the part #K71-653-00 which comes with new shackles and bolts. For a kit that includes new bolts, bushings, and…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Installing Camco Automatic Changeover 2-Stage Propane Regulator on 2013 Rockwood RV

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching