Filter Products
Filter by Style of Part
$5.06 - $5.71
Videos
for Trailer Door Latch
Help Articles
for Trailer Door Latch
Expert Answers
for Trailer Door Latch
Installing the Hinges on your Side-Door Bar Lock Assembly, item #305736, is pretty much up to you and the construction of your trailer. You will need to purchase appropriate hardware to install the Side-Door Bar Lock that you purchased. It is best…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...The Trimax Puck Lock for Trailer Door Hasps #TMX96RR cannot be keyed alike. While disappointing I'm sure, there is another option to consider, which is to…
view full answer...34 inch frame hitch fits are for the cab and chassis model trucks. The part #C15312 does not fit cab and chassis model trucks so it would not be a fit for a 34 inch frame. The part #C15800 is an example of a Curt hitch that does fit a 34 inch wide…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…
view full answer...I have a solution for you but you will need to supply your own pipe to get your desired 33-1/4 inch size. The Universal cam-door lock with 1 inch keeper #383200 will allow you to create a bar lock assembly of 33-1/4 inches. With this item you…
view full answer...From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles -…
view full answer...It is possible to use the cam-door lock, #383200, horizontally but it would need to be placed up higher than the midway point to reduce the amount of stress on it when the door is closed. Take a look at the picture I have included that shows this…
view full answer...Yes, 4.75" is standard for a hub with an 8 on 6-1/2" bolt pattern.…
view full answer...We offer 2 17-1/2 x 6-3/4 wheels that have an 8 on 6-1/2 bolt pattern and a 4.76 inch pilot diameter. I'll run through them below. • #AM22461 is a modular style…
view full answer...The crossbar height is actually the same for the Direct-Connect #RM-523193-5 and Crossbar-Style #RM-523193-4 base plate kits that fit your 2021 Chevy Equinox. Roadmaster lists both at…
view full answer...