Filter Products
Filter Results
$238.14 - $245.58
$291.62 - $291.62
Filter by Amperage
Videos
for RV Surge Protectors
Help Articles
for RV Surge Protectors
Expert Answers
for RV Surge Protectors
Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram…
view full answer...What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are…
view full answer...The 12 volt auxiliary power connections are great for charging a smart phone or running an auxiliary accessory like a DVD player, but these circuits do not have the capability of charging an auto or marine style 12 volt battery. The auxiliary may…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...In general the amount of articulation travel/play when going from an empty to a maximum load with 12,000 pound Dexter Torflex Axles will be about 2 inches in height and less than an inch in length. I have attached a chart and diagram that goes into…
view full answer...You can put a maintenance charge on your trailer battery with the 12 volt accessory circuit of the 7-way. The 1:00 position of your 7-way carries this circuit. You would just need to run a length of 10 gauge wire like part #10-1-1 (sold by the…
view full answer...I have attached a link to our selection of 8 inch trailer hub assemblies that use the common 4 on 4 inch bolt patterns for you to filter through. To choose the correct one you will simply need to remove the current hub on your trailer and check the…
view full answer...Blue Ox has base plate kits that fit your 2023 GMC Yukon XL with the part #BLU54VR which fits the AT4 models with 4L and the part #BLU58FR which fits the non-AT4 models. While we haven't had the chance to shoot an install video for either…
view full answer...You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…
view full answer...You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…
view full answer...