Videos
for Moving Dollies
Help Articles
for Moving Dollies
Expert Answers
for Moving Dollies
The typical tire should run about 158 degrees (Farenheidt) once you get going down the road, but this can vary greatly depending on the weight of the trailer, how fast you're traveling, and also driving habits. So while 158…
view full answer...I have spoken with Lippert about the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817 in they past and they informed me that the most important aspect is that the battery/batteries are sufficiently charged, between…
view full answer...What you are wanting to do is very possible with the GO Power Solar Panel kit part #34273836. You could mount it on your pin box and then run the wiring to your batteries via an SAE connector. We don't have an SAE connector…
view full answer...The caliper bracket you are looking for is the Replacement Mounting Bracket #KCMB12D which is compatible with the 5 bolt mounting flange you have as well as the 225 Kodiak Dacromet calipers you have as well. Then for a bolt kit…
view full answer...I have attached a link to our selection of 8 inch trailer hub assemblies that use the common 4 on 4 inch bolt patterns for you to filter through. To choose the correct one you will simply need to remove the current hub on your trailer and check the…
view full answer...You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…
view full answer...The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.
view full answer...Depending on how your Topkick is equipped, you may need up to 3 items to install a brake controller. If the vehicle does not already have a trailer wiring harness you will first need to install a 4-way wiring harness. Since you seem to have a…
view full answer...Yes, we do carry the Panel Cart/Pushcart Conversion Kit #SLADBPC319-P that you can add to your Snap-Loc All-Terrain Dolly with E-Track Anchor Points #SL1500D6R. By adding this it will give you the same cart as the Snap-Loc All-Terrain Panel Cart…
view full answer...There is actually a single E-Track anchor, #SLSB. Once installed you can then use tie-down #SLARI. Or you can use other E-Track accessories. You can cut down a regular piece of E-Track but it is an extra expense and work that…
view full answer...Trailer Valet created the XL Mounting Bracket #TVXLMB which will allow you to use their RVR's like the RVR9 #TVRVR9 and RVR12 #TV59FR you looked at without having to use the ball in the coupler. Instead you will remove the hitch…
view full answer...First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If…
view full answer...