Videos
for Electric Winch
Help Articles
for Electric Winch
Expert Answers
for Electric Winch
Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they…
view full answer...While trailer axles do feature an upward bend like you are describing, there isn't a particular amount/measurement that is standard across the board. This bend in…
view full answer...Yes, our Dexter leaf spring part #DX74XR is the same as the part number 072-079-00. This is a 7-leaf spring for an 8,000 lb trailer axle that is 24-7/8 inches.
view full answer...The Dexter 10K electric brakes #23-439 (right side) and #23-438 (left side) will have to be manually adjusted using the adjustment wheel below the magnet. To adjust the brakes you will use a small screwdriver or similar tool to turn the adjustment…
view full answer...The Bolt hitch lock part #BL7023582 that you referenced does fit your 2014 GMC Sierra 1500. I attached a chart that has all of the vehicle this works with. I also attached a link to a review video for this lock for you to check out as well.
view full answer...I checked directly with BOLT for you, and they confirmed for me that your 2021 Chevy Silverado is absolutely compatible with their trailer hitch locks. Take a look at the accompanying photo, and if you have the same center cut key, the correct lock…
view full answer...I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.
view full answer...I have a solution for you but you will need to supply your own pipe to get your desired 33-1/4 inch size. The Universal cam-door lock with 1 inch keeper #383200 will allow you to create a bar lock assembly of 33-1/4 inches. With this item you…
view full answer...When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric…
view full answer...The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…
view full answer...