Hey Dave, yes the Timken grease seal part #TMK58ZR is a replacement for what you have now. I would go with the Timken but we also do carry your exact part number replacement with the part #58846.

That is a great question. Both of those are great weight distribution hitches. Between the two, I prefer the Reese Dual Cam II over the Strait Line. The Dual Cam uses an L-bracket to attach to the frame, instead of a chain and lift bracket.…

I was able to find some good pictures of your 2023 Dutchmen Coleman Rubicon 1400BH and it looks like you have ST215/75R14 tires on there. Check the sidewall of the tire to verify this is the correct size. This means you have…

I did a little digging on your grease seal number and it looks like the 16074-224 has an inner diameter of 1.5 inches and an outer diameter of 1.987 so the correct part number you would need is the #10-9.

I do have options for you but most of our frame mounted spare tire carriers are not designed to work with angle iron. That said, the CE Smith Spare Tire Carrier for Trailers part #CE22007Z-11050-2 we have found to work the best so…

The B&W Silencer Pad #BWTS35020 is intended to be placed on the shank of one of their Tow & Stow Multi-Ball Mounts like #BWTS10048B so that it acts like a gasket between the collar on the end of…

You are correct. With your two 6V batteries wired in series to get a 12V output, you will simply charge them using a 12V system like the CTEK #CTEK56353 as if they were a single battery. The charger will connect to the positive terminal on the lead…

On Dexter 9/16-inch lug nut #STN569 the thread pitch is 18-TPI. I went to our warehouse and did a test fit of this lug nut on Dexter hub/drum #8-219-13UC3, which meets your description of an 8-on-6-1/2 Dexter hub with 9/16-inch studs for 7K axles.

Yes we do, the correct oil seal you would need is the part #10-56 which I verified has same dimensions as the 295924 that you have now.

Yes, the Replacement Short Arm Assembly for RV Awnings part #LC404523 is correct for a Solera V000436372 Awning.

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the…

To replace your defective Power Gear 130-1305 RV Slide-Out motor, you'd use the LCI #LC368446 as confirmed by Lippert. The LCI #LC386322 motor you referenced replaces a different Power Gear motor, the 13-1127, so…