Videos
for Boat Covers
Help Articles
for Boat Covers
Expert Answers
for Boat Covers
The TruXedo Boat Windshield Cover #TX38FR places the polypropylene against the windshield to protect it from scratches. If you were to put the fabric side against the windshield it could hold particles of dirt and debris. While in tow the cover…
view full answer...The plunger pins are usually specific to the brand of jack and usually are not interchangeable. Unfortunately, without knowing the manufacturer and model number of your existing jack, I cannot say with certainty that the pin will work for you. I…
view full answer...The easiest replacement option for your Duo-Therm 620426.321 is the Advent Air Replacement RV Air Conditioner for Dometic Setup w/ Start Capacitor #ACDOM150 you were looking at. This system comes with a wiring harness adapter that will make…
view full answer...Hi Sean, We do offer the Ground Control 3.0 for prepped trailers part number 2021106810 as part #LC52ED. This is going to include the rest of the components needed to complete the system. Since we don't have a video of this kit yet…
view full answer...I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel…
view full answer...I check with Phoenix Faucets and they said the thread diameter of the #PF182011 is 1-1/4 inch.
view full answer...The Ford Q-206 document is one that we hare very familiar with since it shows the nearly inaccessible location of the brake controller port! For the 2006 Ford F-53 chassis you should be able to use harness #3035-P to plug in a P3 brake controller…
view full answer...On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.
view full answer...According to my research you should need 25-1/8" long springs rated for a 3,500 lb axle which means you'll need the following parts: - 3.5K Leaf Spring #e54SR OR Upgrade to part #e68SR - U-Bolt Kit #CE23002 for Round Axle OR…
view full answer...The DeeMaxx Disc Brake Kit #DE82FR has the bolts and all other parts necessary to replace the Kodiak #K2R526DKG on your trailer. The bolts are already in place in the pictures for the DeeMaxx, unlike the Kodiak where we have them sitting out…
view full answer...My contact at Dexter Axle tells me that when installing a brake assembly to the backing plate of a 3500 lb axle, the bolts should be tightened in a criss-cross pattern to between 45-70 foot lbs.
view full answer...The DeeMaxx Disc Brake Kit #DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.
view full answer...