The TruXedo Boat Windshield Cover #TX38FR places the polypropylene against the windshield to protect it from scratches. If you were to put the fabric side against the windshield it could hold particles of dirt and debris. While in tow the cover…

Hi Sean, We do offer the Ground Control 3.0 for prepped trailers part number 2021106810 as part #LC52ED. This is going to include the rest of the components needed to complete the system. Since we don't have a video of this kit yet…

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

The DeeMaxx Disc Brake Kit #DE82FR has the bolts and all other parts necessary to replace the Kodiak #K2R526DKG on your trailer. The bolts are already in place in the pictures for the DeeMaxx, unlike the Kodiak where we have them sitting out…

My contact at Dexter Axle tells me that when installing a brake assembly to the backing plate of a 3500 lb axle, the bolts should be tightened in a criss-cross pattern to between 45-70 foot lbs.

The DeeMaxx Disc Brake Kit #DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Overpacking the trailer hub with grease is the number one reason for grease seal failure. For a boat trailer I would recommend re-packing the hubs by hand with grease once per season and you'd be fine. I don't like recommending people use…

The main difference between the two covers that you mentioned is the application for the two. The Classic Accessories DryGuard Waterproof Boat Cover #CA20085 is designed for bass and fishing boats whereas the Classic Accessories Boat Cover…

The diameter of the top plate on the #JSC-30 is 9 inches. This top plate is also the mounting plate as the bottom is what touches the ground. The holes on this plate are 7-7/8 inches apart measured across.

I can help you add reverse lights to your trailer. Yes, It is important to pay attention to DOT compliance when adding lights on your boat trailer. Compliance will be met if you use the Optronics #BUL10CB light as your backup light. The #BUL72CB is…

To replace your 1,700 lb Shelby 5407B winch I recommend the Dutton-Lainson Single Speed Winch #DL14627 which is rated for 1,800 lbs. This winch features permanently lubricated bearings, high carbon steel gears, and a Zinc TUFFPLATE finish for…