bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Winnebago


  • Recommended Solution for Adding Charge Line for Flat Towed Vehicle
  • It sounds like you're looking for the Roadmaster Battery Charge Line Kit for Towed Vehicles # RM-156-25, which will allow you to keep the battery on your 2005 Jeep TJ charged; this will tie into the 7 way tow bar wiring/light kit you've got. If you don't have a charge line on your RV's 7 way then you'll also need the Roadmaster Battery Charge Line Kit for Motorhomes # RM-156-75. I've linked some review and installation videos of these parts for you to check out.
    view full answer...

  • Hitch Adapter and Bike Rack Recommendation for E-Bike and Flat Towing
  • To replace your Roadmaster High-Low Adapter # RM-048-8 I recommend using this replacement shank from Gen-Y: - Replacement Shank for Gen-Y Adjustable Ball Mount # 325-GH-404 I like this option because it's more heavy-duty than pretty much every other adapter, plus it has a receiver above the shank so your bike rack will be at a higher location for better clearance. Then for a bike rack I recommend using the Swagman E-Spec # S94FR and then using the Swagman Ramp and Bridge # S32YR to...
    view full answer...

  • Wiring Adapter Needed To Install Tekonsha Prodigy P2 Brake Controller On 2009 Winnebago Journey 34Y
  • The Tekonsha Plug-In Wiring Adapter # 3027-P will plug into the factory port on your 2009 Winnebago Journey 34Y motorhome. This will allow you to connect to the Tekonsha Prodigy P2 Trailer Brake Controller # 90885 without splicing any wiring.
    view full answer...

  • Parts Needed To Flat Tow A 2004 Dodge Dakota With A Falcon 5200 Tow Bar
  • Yes we can definitely help set you up. For replacement pins you will need the # RM-910008-00.This is the 3/4" diameter pins and they will be compatible with your Roadmaster Falcon 5200 Tow Bar. You will also need a base plate to go on the front of the towed vehicle. I see you were searching for parts for a 2004 Dodge Dakota. If this is the vehicle you plan to flat tow, I recommend the # 266-1 for 4 wheel drive models, or the # 271-1 for 2 wheel drive models. You will also need the quick...
    view full answer...

  • Recommended White Handle for a LaSalle Bristol Fresh Water Drain Valve
  • The Replacement Handle for LaSalle Bristol Cable-Actuated RV Waste Valves # 34490CMA1 is not available in white, however you could either just paint it white or use the Replacement Handle for LaSalle Bristol Waste Valves # LSB97FR.
    view full answer...

  • Steering Stabilizer for 1997 Winnebago Vectra Motorhome on Freightliner Chassis
  • Your 1997 Winnebago Vectra Motorhome with air suspension is built on a Freightliner chassis and so you can use Roadmaster Steering Stabilizer # RM-RBK14-RSSA so long as it HAS a solid front axle and does NOT have the 150-gallon fuel tank. This is the item you referenced in your question.
    view full answer...

  • Spare Tire Holder For A 2022 Winnebago Travato
  • To use the hitch mounted spare tire holder like # RM-195225 you will slide the spare tire holder into your receiver opening on your hitch, and from here bolt your spare tire to the mounting plate of the spare tire holder. As far as a spare tire holder for your ladder, we unfortunately do not have anything.
    view full answer...

  • Picking Out The Correct Replacement Roof Vent Lid For A 2016 Minnie Winnie Motorhome
  • For your 2016 Winnebago Minnie Winnie Motorhome, we do have several options that'll work great for you like the: -MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent # MA00-335001 for translucent white, Or, -MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent # MA00-335002 for translucent smoke. These are universal fitting and will fit just about any vent on the market right now, however if you want to replace your lid with something more custom...
    view full answer...

  • Parts Needed to Flat Tow 2019 Ford Ranger Behind Motorhome
  • According to the extensive procedure outlined in the owner's manual, your 2019 Ford Ranger is capable of being flat towed. In order to tow the vehicle behind your motorhome, you'll need base plates like part # RM-524459-5, a tow bar like the Roadmaster Falcon 2 all terrain tow bar, part # RM-522 and safety cables like # RM-643. You'll also need to wire the vehicle so its taillights operate in tandem with those on the motorhome. To do this, I'd recommend a diode system like # RM-152-98146-7. You...
    view full answer...

  • Difference Between Snap Pads # SP64FR84 And Snap Pads # SN76FR
  • The SnapPad EQ Plus Jack Pads # SP64FR84 will work on class A and class C motorhomes with equalizer leveling systems that has 2 octagon jack feet and 2 round jack foot. The SnapPad EQ Octagon Jack Pads # SN76FR will work with class A, B, and C motorhomes. These are for Octagon Jack feet. With you having 10 inch round feet you will need The SnapPad Prime Jack Pads for Power Gear Leveling Systems # SP84FR4. These feet will work with class A and class C motorhomes with Power Gear or Kwikee...
    view full answer...

  • Recommended Storage Cover with Side Zippers for Coachmen Clipper 17BH
  • It looks like the exterior length of a new Coachmen Clipper 17BH is 20'-5", so I recommend using the Adco SFS AquaShed Storage Cover # 290-52241 since it's going to give you great protection in all climates. This cover does have zippered panels on the passenger side of the coach to allow entry and the reinforced elastic corners provide a nice, snug fit. I've linked a review video of this cover for you to check out.
    view full answer...

  • Lift Kit Recommendations For A 2017 Winnebago Micro Minnie 1700BH Travel Trailer
  • It looks like the pictures didn't come through, however, your trailer is common enough where we have answered something like this before. With that being said, we do have a couple options for you: The most common type of lift kit is the "over-under" kit which will flip your axles from the top to the bottom. Determining which kit is right for you will depend on your axles diameter plus the leaf spring pack height. If you have a 2-3/8" diameter axle, then the Dexter Trailer Springs Over-Under...
    view full answer...

  • How to Determine Which Trim Insert Is Needed for My 2004 Itasca Suncruiser Motorhome
  • All you're going to have to do to determine which trim insert you need s measure the available width inside your trim. We currently carry 3/4" # CAM25262 and a 1" trim insert # CAM25202 for you to choose from.
    view full answer...

  • Replacement Storage Door Gasket Material For a 2019 Winnebago Micro Minnie Travel Trailer
  • In my experience for storage doors the Ribbed Rubber Seal # SR88FR is generally all that is required for the weather stripping. This seal is 3/16" thick so you will want to gauge the thickness required on your door. A good way to do this it to clean off the gasket material that is already there and use putty to determine how thick the material needs to be for the door to seal properly. It is a good idea to check this in a few places to also determine if your door is bent and that is what...
    view full answer...

  • Is HDMI to AV Adapter Needed for Jensen RV Stereo JWM60A
  • You could probably find an HDMI to AV adapter out there that would work with the Jensen RV Stereo w DVD Player # JWM60A but most of the ones I've seen do require that AC power. If you haven't purchased this stereo yet then I recommend picking up a different one like the Jensen # JWM45 or iRV # IRV64FR that already has the HDMI port so you aren't digging yourself a hole prior to your purchase. These are a little smaller than the one you were looking at but they carry the same basic features...
    view full answer...

  • How Many Slide-Out Supports Do I Need for 2 Slide-outs
  • The Ultra-Fab Slide-Out Supports # UF19-960003 come in pairs and are designed to be used with one pair on each slide-out. Since you've got 2 slide-outs, you would need 2 pairs of the Ultra-Fab Slide-Out Supports. These supports are designed to support up to 1400-lbs per set and can be used on slides that have a height from the ground between 26" and 47" tall.
    view full answer...

  • Recommended Dash Pedestal Mount For Voyager 7 Inch Monitor
  • The Voyager Universal Monitor Mount # VOSHD6MNT is the correct mount for the Voyager WiSight 2.0 Wireless Backup Camera System # ASA37YR. Adjustable monitor mount secures to your dashboard and holds up to a 7 inch monitor. The bracket has a simple installation with minimal drilling required. Using this pedestal will help with rough roads and keeping the camera in place. If you have any further questions please reach back out to me anytime and I would be more than happy to further assist you.
    view full answer...

  • Does Replacement Control Module for Kwikee 909513 Come Without Switches
  • The Replacement Control Unit for Kwikee Electric RV Steps - 2 Door Switch Kits # LC379606 is the correct replacement control unit for 909513. It does come with the switches though and there isn't a replacement unit for your model that comes alone without the switches. I have added a link to a video review for you to check out as well of the Replacement Control Unit for Kwikee Electric RV Steps # LC379606.
    view full answer...

  • How to Determine if Longer U-Bolts are Needed When Upgrading Anti-Sway Bar for 2015 Vista 27N
  • To determine whether or not a longer U-Bolt kit is needed when you install the Roadmaster Rear Anti-Sway Bar # RM-1139-146 on your 2015 Winnebago Vista 27N Motorhome you need to look at your current U-Bolts and take a measurement. The bracket that comes with the anti-sway bar kit is 1/2" thick so you just have to make sure that you have 1/2" of extra space on your current U-Bolts plus room to have 3 threads left over. If you have enough room then you don't need the longer U-Bolts. If you...
    view full answer...

  • Replacement Motor for Kwikee Series 32 Steps
  • Based off of the part number you referenced it looks like you might actually have Kwikee Series 32 steps. In order to replace the motor on those you'll want to use the Motor Upgrade Kit for Kwikee Electric RV Steps # LC379145 which will replace the motor and give you an improved gearbox for your steps. This kit is compatible with Kwikee Serieseries 22, 23, 28A, 30, 32, 33, 34, 35, 36, 38, and 40 steps.
    view full answer...