According to MagnaFlow the Stainless Steel Catalytic Converter, # MF23256, is the direct fit, 49 state catalytic converter for the 1995 Chevrolet K-1500 Suburban with a 5.7L engine. At this time there is not a California approved direct fit application for your Suburban.
I also checked on a Cat Back exhaust system for your 1995 Suburban and direct fit systems are only available for 1996 and newer K-1500 Suburbans with the 5.7 liter engine.
I added links to a couple of informational articles... view full answer...
In order to mount Thule WingBar Evo Crossbars # TH711400 on a 2008 Chevy Suburban with the factory rails you'll want to use the Evo Raised Rail Feet # TH710401. This foot pack will connect to the raised side rails on your Suburban and allow you to mount the WingBar Evo Crossbars. view full answer...
When it comes to getting a replacement rim for your 1995 Coleman popup camper The Steel Trailer Wheel - 10 inch x 6 inch Rim - 5 on 4-1/2 - White # AM20046 will work for you.
This rim has a sturdy steel construction that has a white paint finish that helps resist corrosion. It has a wheel bolt size of 1/2 inch-20 with a pilot diameter of 2.81 inches and has a weight capacity of 1,650 pounds.
If you need a replacement tire The Loadstar K399 Bias Trailer Tire - 205/65-10 - Load Range C... view full answer...
The K-Source Replacement Side Mirror - Electric/Heat w Signal, Lamp, Memory, Power Fold - Driver # KS62160G is not available without the glass; you would need to buy the entire assembly. This mirror has the electric folding option that you need and it is for the driver side; if you need the passenger side you can find it here # KS62159G.
As a side note, I would make sure your current mirror is faulty and that it is not an electrical issue in the wiring circuit. If it is just an electrical... view full answer...
When it comes to installing tow mirrors on your 2015 Chevrolet Suburban The CIPA Universal Fit Towing Mirrors - Strap On - Qty 2 # 40375-2 are confirmed to fit your vehicle.
These universal-fit towing mirrors strap onto your factory mirrors to extend your lines of sight by 5 inches. They are made out of a durable ABS plastic, and the mirrors have an aerodynamic shape and a snug fit to help reduce vibration and wind noise. They have a simple, tool-free installation and removal.
I have... view full answer...
The size seal you will need will depend on the part number of your inner bearing.
If the outer bearing part number is L44649 and the inner bearing part number is also L44649, then you will use a TruRyde Seals, # RG06-020.
If the outer bearing part number is L44649 and the inner bearing part number is L68149, then it will be TruRyde Seals, # RG06-050.
The size grease cap you will need is 1.986 inches.
For the standard spindle you would use the TruRyde Grease Caps, # RG04-020.
If... view full answer...
The Surco Safari Rack 5.0 Cargo Basket # SPS5084-1101 is the largest basket we have at this time. It's 84 inches long and 50 inches wide.
The unique thing about this basket is it fits onto raised side rails like on your 2008 Chevrolet Suburban so you won't need any additional parts. view full answer...
There is a two-piece bracket set-up that works best. Use the part # C57202 long bracket along with the 7-way mounting bracket, part # 18138. If you are replacing the OEM hitch and having to remove the OEM 7-way bracket, the OEM 7-way is a twist-in style that would need to be replaced with # PK11893. view full answer...
Although the Timbren # TGMRYS4 would work for you, I'm not certain you'd be happy with the ride quality you'll experience once the suspension of your Suburban compresses and the preload is taken up which is when the helper springs come into play. The Timbrens offer up to 6000 of additional support which is way more than you'll need to offset the tongue weight of your travel trailer.
The SumoSprings # SSR-204-40 add 1000 lbs of additional support, and they're made of a more pliable material... view full answer...
For a 2002 Chevy Suburban the correct Tekonsha brake controller wiring harness is # 3025-P. If your Suburban did not come with a 7-Way trailer connector you will also need to add one using # 30955. Or you will need # PK11998 and # PK11893 or 30955 if you do not have a 7-Way and just have blunt cut wires above the spare tire.
There may also be some connections you will need to make under the hood to make everything fully functional. I have included a link to an FAQ article to the right... view full answer...
Timbren makes spacers specifically for the Timbren Rear Suspension Enhancement System # TGMRSB4S on your 2011 Chevrolet Suburban 2500. You have the option of using the Timbren 1" Spacer For Raised Frame Vehicles - 3/8" Bushing # A25723-90AH00 or Timbren 1/2" Spacer for Raised Frame Vehicles # TA25722-90P00.
Typically you want to see 1/2" to 1-1/2" of space after installing the Timbren system. Since your lift is about 4" you will likely need 4 of the 1" spacers on either side but you may... view full answer...
There is currently not a custom hitch confirmed for your 2014 Chevrolet Suburban.
The only option that would work for you is The Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2 inch # 41990-07 and have it welded onto your frame. Keep in mind with this hitch though it shows that it can tow up to 16,000 pounds and has a tongue weight up to 600 pounds but your vehicle can only tow up to 4,200 to 8,100 pounds depending on what kind of engine, gear ratio you... view full answer...
I have a great Pioneer Platform solution for you. However, unfortunately, there is no way to attach the Rhino-Rack Pioneer Platform # RR45TB to your factory crossbars on your 2022 Chevy Suburban. There are no add-on accessories that work.
However, with that being said, Rhino-Rack does make Pioneer Platforms that are a universal fit for crossbar systems. Those are the following platforms:
- Rhino-Rack Universal Pioneer Platform Rack for Crossbars - 58" Long x 47" Wide # RR42115BF
-... view full answer...
The current Yakima round bar roof rack that fits your 2002 Dodge Grand Caravan consists of parts # Y00408, # Y53TR, # Y03536 and # Y00224. All roof rack fits for the 2003 Suburban are shown on the linked page but no Yakima branded racks are among them.
You can select your roof type using the drop-down menu tool at the top of the page to see roof racks that will work on your 2003 Suburban.
If you have factory roof tracks then a cost-effective square bar rack confirmed to fit is the Inno... view full answer...
In order to swap the controller back and forth between vehicles, for the 2010 Suburban you will need the # 7894 pigtail and a # 7686 mounting bracket.
The pigtail will wire up to the tow package wiring in your Suburban as follows:
• Tow package red/black striped wire connects to black pigtail wire
• Tow package light blue wire connects to red pigtail wire
• Tow package dark blue wire connects to blue pigtail wire
• Tow package white wire connects to white pigtail wire
I've linked... view full answer...
If you've got a Westin Sportsman Grille Guard like the # 40-0180 or # 40-0185 then you can use the Replacement Mounting Hardware Kit for Westin Sportsman Grille Guard - Manufactured After 2006 # 40-018PK. view full answer...
If your 2001 Chevy Suburban 2500 came with a factory installed 7-Way trailer connector then you can use brake controller wiring harness # 3025-P with the P2 controller # 90885. There may be some additional connections you will need to make under the hood to make everything fully functional. I have included a link to an FAQ article that will help.
If your Suburban did not come with the factory 7-Way you will need to add one using # 30955. The connector to plug this 7-Way into is located... view full answer...
Since your vehicle's 6 way round already has a brake controller line run the external wiring will be in place- so I recommend using the Adapter 6-Pole to 7-Pole Trailer Wiring Adapter # 47435 to give you an adapter to plug in your trailer's 7 way.
For a brake controller I recommend the Tekonsha Primus IQ # TK90160, which will give you proportional braking for your trailer. This controller will need to be hard wired into your 1997 K2500 Suburban, but offers automatic leveling so it can... view full answer...
Your 1998 Chevrolet Suburban does not have an under-dash brake controller port like your F-150 did so to install your Prodigy P2 # 90885 in the Suburban you'll just use our brake controller installation kit # ETBC7 to hard-wire it. You need to have a working 4-pole harness on the vehicle to do this; if you need a 4-pole flat harness you can use # C55319 which is a plug-and-play part.
The linked video shows the ETBC7 being installed in a 1999 Suburban and a helpful article is included too. view full answer...
Exactly what the term "tow package" means varies a lot between car makers, vehicle models and model years. Sometimes the term refers to a trailer hitch, heavy-duty suspension and fluid coolers, wiring harnesses, brake controller or all of the above. The best way to confirm exactly what equipment went into your Suburban at the factory is to ask your local dealership to look up the truck's VIN.
We do not show a 2007 Suburban having a built-in OEM brake controller. However, we do show that... view full answer...