The Inno Square Bar Roof Rack # INB127, # INSUT, # INK876 that you referenced is confirmed to fit your 2015 Honda Fit.
This roof rack uses custom fit pads and clamps to provide a secure fit for the roof rack on the naked roof of your Fit. The clamps are designed specifically to fit the curves of your vehicle's doorjambs.
The molded pads that install on the bottom of the roof rack feet help to protect your roof from scratches and abrasions. Anytime an accessory installs with direct contact... view full answer...
Trailer hitches are vehicle specific and Curt hitch # 13534 is designed to fit a 2008 to 2013 Toyota Highlander. It will not fit a 2013 Honda Fit.
Trailer hitches for the Honda Fit are much smaller because the vehicle is not as capable as a larger SUV or truck. I have included a link to the trailer hitches that will fit your vehicle.
If you are looking for a hitch to carry something like a bike rack then I recommend EcoHitch trailer hitch # 306-X7286. For a bike rack, I recommend the... view full answer...
The Rhino-Rack Aero Bars measure 3-1/8 inches wide. The Curt basket, # C18115, will fit bars up to 3 inches wide so it will not fit the Rhino-Rack bars. The Thule basket, # TH859XT, is designed to fit bars of many widths so it would be a great choice for you. I have included a link to a video review of this basket for you. view full answer...
If you're going to be listening to Taylor Swift you might need a higher fuse rating! But seriously the fuse bypass for your 2012 Honda Fit, # RM76511, is rated for a maximum 20 amp fuse. But, you really only have to pull the fuse if you will be towing for more than 8 hours. Otherwise you can pull over somewhere and then start up the Fit to let the alternator charge up the battery. Be sure to follow the flat towing prep information from the owner's manual prior to towing the vehicle again... view full answer...
On your 2016 Honda Fit, the Rhino-Rack roof rack consisting of # RRVA118B-2, # RRRLKVA, and Fit Kit # DK438 are a confirmed fit. This rack is rated for 165 lbs and has a 29.5 inch crossbar spread. This rack will allow you to carry two paddle boards when you use an appropriate carrier. I recommend the Inno Locker Watersport Carrier w/ Crossbar Pads - Locking - Clamp On - 1 Boat or 2 Boards # INA446. This carrier has a locking design to secure your paddle boards once they are mounted... view full answer...
The Curt Trailer Hitch Receiver, part # C12021 you referenced is designed to fit the 1991 through 1997 Isuzu Rodeo and the 1994 through 1997 Honda Passport.
This is a Class ll hitch and it has a 1-1/4 inch receiver opening. view full answer...
Yes, the Curt Class I Hitch, # C11064, will fit a 2010 Honda Fit Sport. It is a 1-1/4 inch Class I hitch that has a 2,000 lb. towing capacity and a 200 lb. tongue weight capacity.
For towing you will need a hitch ball like the Tow Ready 2 Inch Hitch Ball, # 19258. The wiring harness you will need is the Tow Ready T-One Vehicle Wiring Harness, # 118420. This harness will plug into the factory blue 3-pin connector located in the rear cargo area behind the vehicle's taillights. This will... view full answer...
I spoke with my contact at Swagman and she informed me that the Swagman Roof Rack # S64710 that you referenced can be installed on cross bars that are up to 52 inches apart measured from the center of each bar to the other bar center. Check out the review video and installation instructions I attached for this product.
The maximum cross bar width the clamps of the product can attach to is 3 inches. view full answer...
A Class I hitch like the Draw-Tite # 24920 would use a 1/2 inch diameter hitch pin. If the bike rack you're interested in is compatible with a Class 1 hitch with a 1-1/4 inch receiver, it will be compatible with the hitch.
The Thule Hitching Post Pro # TH934XTR for example would be perfectly compatible with a Class I hitch, although you'd be limited to carrying two bikes on it due to the low tongue weight capacity of a Class I hitch. Thule also offers a similar rack that can carry two... view full answer...
The Kodiak XL ProLube Kit # XLPROLUBE2440KIT will work with your 7,000 lb. idler hubs as long as your existing hub features a 2.440 hub bore diameter. This kit includes 2 seals that have an inner diameter of 2.25 inches and an outer diameter of 3.376 inches so you will also want to verify that this matches your existing grease seals. view full answer...
The Curt Class I 1-1/4 Inch Hitch, part # C11064, is a Class I hitch for the 2010 Honda Fit.
You will want to check that the Saris Thelma 2 bike carrier will work in a Class I 1-1/4 Inch hitch. I checked online and it says it fits the 1-1/4 inch hitch, so you will be good to go. I do not sell the Thelma model.
You will need the support strap # 18050 and will be limited to only to bikes on any class I hitch.
I am including links to FAQ pages on trailer hitch classes and sizes. view full answer...
Yes, you can use the 60 inch Thule WingBar crossbars # TH711500 on your 2007 Honda Fit Sport. You will need a set of Rapid Traverse feet, # TH480R, and fit kit # THKIT1312 to complete the installation. The WingBars are also available in black using # TH711520.
The recommended bar length for your Fit is 47 inches. The 60 inch bars will stick out about 6-1/2 inches more on each side of the vehicle so use caution. view full answer...
Good news, from my research it appears that the Badlands Winch 61383 has a mounting bolt pattern of 3 inches x 4-7/8 inches which will fit the mounting hole pattern of the Bulldog ATV Winch Mount # BDW15181 you were looking at. The Bulldog ATV winch is confirmed to fit the 2016 Honda Rancher 420.
Since you didn't tell me the specific model you were referring to, you will want to check the bolt hole mounting pattern to be for certain.
I have linked the product to this page for your purchasing... view full answer...
I have a solution for you. Even though the Curt Roof Mounted Cargo Basket # C18115-117 only weighs 44 pounds, it is only designed to fit crossbars that are a maximum of 3" wide x 1-5/8" tall. Since the Rhino-Rack Vortex Aero Crossbars # RRVA118B-2 are 3-1/8" wide x 1-3/16" tall, the Curt basket will not be able to mount on the crossbars.
For a great basket that will fit the Rhino-Rack Vortex Crossbars, I recommend the Rhino-Rack Roof Mounted Steel Cargo Basket - 57" Long x 42" Wide #... view full answer...
A naked roof is a vehicle roof with no existing rails or crossbars. I've attached a photo showing tow of the different roof types for you to be able to see the difference. The other types of roof styles are Factory Roof Rack and Fixed Mounting Points.
Your 2007 Honda Fit Sport has a naked roof and the SportRack Semi-Custom Roof Rack for Naked Roofs # SR1002 is a fit for your vehicle. I have attached a review video and the rack's installation instructions for you.
If you're interested... view full answer...
The Curt trailer Hitch # C11406 will NOT be the right fit your 2013 Honda Fit but would fit a 2015 Honda Fit. The trailer hitch I would recommend for your 2013 Honda Fit is the EcoHitch # 306-X7286.
If you plan on doing any towing with your 2013 Honda Fit please refer to the owners manual to view towing maximum limits.
I have included installation details and video for you as well. view full answer...
The roof racks for a 2015 Honda Fit all have around a 30" cross bar spread which is the distance between the cross bars. This is important as the wider cross bar spread you have, the larger cargo box you can carry. The Yakima SkyBox 21 Rooftop Cargo Box part # Y07337 and Yakima SkyBox 18 Rooftop Cargo Box part # Y07336 will both accommodate a crossbar spread of 30" so yes, they will fit. That said, they would be pretty large up on the roof and you won't be able to open the hatch all the... view full answer...
Though I am partial to j-style carriers, all of our kayak carriers that can clamp to crossbars will work with the SportRack Semi-Custom Roof Rack for Naked Roofs - Square Crossbars - Steel - 50" Long, part # SR1002, with the exception of the Thule Hullavator. This roof rack has a maximum weight capacity of 130 lbs.
My recommendation is the etrailer J-Style Kayak Carrier - Folding - Universal Mount, part # e98878. It comes with two cam straps and bow and stern tie-downs.
I have included... view full answer...
The 2013 Honda Fit Online Reference Manual on page 159 states that both manual and automatic transmission equipped Fit models can indeed be towed behind a motor home if the specific preparation procedures shown are followed. Those procedures are critical to avoid damage to the vehicle. I urge you to review and follow the guidelines shown in your owners manual and if you have any uncertainty contact your local Honda dealership for clarification about your particular vehicle. The vehicle... view full answer...
For your 2008 Honda Fit with a bare roof the Inno 50-inch square bar roof rack made of parts # INB127, # INSUT and # INK219 is a confirmed fit and will give you a sturdy cost-effective platform for transporting your two 50-lb kayaks. This rack has a 120-lb maximum weight rating and 28-inch bar spread.
We have lots of choices in kayak carriers that fit on these square Thule crossbars and these appear on the linked page. You might care to check out the linked article on watersport carriers... view full answer...
Go To Results