Though the amperage of the Greystone Built-in Microwave with Trim Kit # 324-000105 is not a number that is available, it is a 900 watt, 120 volt microwave that can fit in a space that measures at least 23-3/8" wide x 15" tall x 13-1/2" deep. view full answer...
The Yakima OnRamp Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount, part # Y36FR, has a different weight limit when on a RV or motorhome. On your Class C motorhome the per bike weight limit is 40 lbs, so it is not really ebike capable on a motorhome. A better option would be the Hollywood Racks Sport Rider SE, part # HLY84FR. It is rated for use with RV/motorhomes, without a weight reduction - that weight limit is 80 lbs.
I have included a product description link and a video... view full answer...
When we have asked Thule about how far the Thule Hullavator Pro Kayak Carrier and Lift Assist # TH898 hangs down from the top of the crossbars, they told us that it will extend down 40 inches, as you can see in the accompanying photo I added for you.
The one thing I do recommend with the Hullavator is to add the Thule One-Key System Lock Cylinders # TH450200 to lock it to your rack, helping protect your investment.
I have added a link to a video review for you to check out as well of... view full answer...
I have attached an image of the Draw-Tite Ultra Frame Trailer Hitch Receiver # 41947 referenced in your question with a few dimensions labeled.
The distance between mounting holes, from the left side mounting bracket to the right side mounting bracket is 30-1/2 inches. The distance between the mounting holes, center to center, is 3-1/2 inches for the closer of the two holes and 15-7/8 inches from the hole nearest the receiver to the rear bracket hole.
If you need any additional measurements,... view full answer...
First, the Curt rack # C18085 is not approved for use on a motorhome. Instead, I recommend the Thule Hitching Post Pro Bike Rack for 4 Bikes - 1-1/4" and 2" Hitches # TH934XTR. The distance from the hitch pin hole to the closest upright bar on the rack on the # TH934XTR us 13-1/2" then you have additional inches to the first cradle so this should work well for you. Additionally, I chose this 4-bike rack for you so you could simply not use the closest cradle giving you plenty of room outward... view full answer...
The 3-3/4" measurement is measuring to the triangle piece/gusset. This does have some slight variation depending on the weld. After measuring I found that the distance from the center of the closest hole to the base of the gusset is approximately 4". The distance from the closest hole to the upright is 7". view full answer...
A 10 amp controller could easily handle a total of 155 watts of solar panel power so yes the Go Power Solar Flex Expansion Kit # 34280125 would work for you. view full answer...
The capacity of scissor jacks is based on the individual jack. For example, the Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 10,000 lbs - Qty 4 # TJSCHD-24-4 each have a 2,500 lb capacity, but since these come in a quantity of four, the capacity is a total of 10,000 lbs.
Since your 2019 Micro Minnie 2100BH has a 7,000 lb GVWR, these scissor jacks would have more than enough capacity, and it is recommended you replace all of them at the same time.
If you were instead referring... view full answer...
That depends, your 2012 Winnebago's maximum gross trailer weight and maximum tongue weight are independent of those corresponding values of your hitch receiver. You are limited to the lower of the two values between your motorhome and the hitch receiver, so going with a hitch receiver with a higher maximum tongue weight does not guarantee you can carry anymore weight. You will have to contact the manufacturer to find out the frame capacity of your Winnebago. view full answer...
The distance/height from the ground to the mounting plate on the Ultra-Fab Rotating, Hitch Mounted Skid Wheels for RVs # UF48-979014 is 5-3/4". view full answer...
Per Swagman, the XP Folding 4 Bike Rack, part # S64960, has a weight capacity of 35lbs per bike with a total weight limit of 100lbs.This rack is compatible with 1 1/4" and 2" hitch receivers, it locks your bike/s to the rack, and it tilts forward while empty so you can access your trunk or hatch.
If you will be carrying women's bike/s with a step-thru frame you will also need a bike frame adaptor bar for each of them. The Swagman Deluxe Bike Frame Adapter Bar, part # 64005, will work... view full answer...
Looks like your Winnebago RL2500 has 14 inch wheels that are steel which would mean you'd want to tighten the lugs to 75-85 ft lbs with a torque wrench like part # PTW3001C. view full answer...
According to Yakima, the Yakima ShowDown Kayak or SUP Carrier and Lift Assist # Y04081 will hang down 26 inches from the top of the crossbars.
I do recommend adding the Yakima SKS Lock Cores # Y07202 to lock the ShowDown to your rack and help protect your investment.
I have added a link to a video review for you to check out as well of the Yakima ShowDown # Y04081. view full answer...
The diameter of the Jensen Antenna # 44US01R ball is approximately 7/8". Unfortunately we only sell these altogether and do not sell the masts separately. view full answer...
The Lippert Reel Away Short Covered Storage Reel with Hand Crank for 50' Long Power Cords # LC677583 is 17-3/8 inches long at the base and 13-1/2 inches wide without the handle. The handle adds 2-7/8 inches to the width for a total of 16-3/8 inches. The unit is 14 inches tall. I've attached a video to help. view full answer...