While we do carry Hinges # LC95VR, Latches # 295-000019, Gaskets # CS94VR and other parts for trailer doors we do not carry entire door assemblies. Based on your dimensions you will likely need to have a custom door built which you may be able to have done at a local trailer manufacturer in your area. view full answer...
Based on images I could find of Lark enclosed trailers with a double rear door it looks like you are going to need the Kit # PLR258-002. This will give you the mounts, handle, and catches for your trailer but you will need to source the 3/4" steel pipe and hardware needed locally and have the handle and cams welded to the pipe.
If you have something different from this type of setup please send me your images and dimensions for the parts you are looking to replace. view full answer...
Unfortunately Eugene, the door itself is not going to be something you can replace. You're going to need to replace the entire receptacle with the 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket # HM40975 or the CR Brophy Replacement 7-Pole, Trailer Connector Socket # R7CB if you just have a 7 way. view full answer...
Hey Perry, so due to the door style that is at the rear of a 2023 Mercedes Sprinter the Inno tilt cargo carrier part # IN94MR wouldn't allow the door to open as it would sit up too tall even folded down but I do have a similar solution that would work.
You would need a carrier that swings away from the rear of the vehicle like the Yakima EXO part # Y62VR which would allow the rear door to open without interference. view full answer...
Welcome back! I have a couple of options for a wiring harness but it depends on what model your 2010 Subaru Impreza is. From what I can tell the Outback Sport model is a hatchback so if that's the case you'll need the 5-Door Wagon option but wanted to list both.
Sedan - Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector item # 56061
5-Door Wagon - Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector item # C56111 view full answer...
Hey Thomas, yeah you could install and use the Access Door for RVs part # 37210-31015 the way you described and it would work well. It is waterproof so in the future it wouldn't leak either. view full answer...
Hey Jan, to locate the Torklift Generator carrier part # TLA7752 off-center in front of only one of the doors would require finding a welder/fabricator in your area who could add an additional hitch opening off to the side. This is such a rare request there isn't a product available for this specific application. view full answer...
The Bauer Products Motorhome Door Lock 402-112-000 # BA64FR has 1/4" diameter pins with 1/2" diameter on the ends of the pins. If this was not the pin size you needed please let me know as I did not see any pictures attached. view full answer...
Thanks for the photos and details Darcey!
The lock you're looking for is the Bauer Products Motorhome Door Lock # BA64FR which fits a cutout of 5-1/4" wide x 4-1/2" tall. It uses the same type of dual lock and bolts like what your have on your lock as well.
Attached is a video for your reference - let me know if you have any other questions! view full answer...
Hey Jared, the Yakima Backswing bike rack part # Y02465 that you referenced does have the needed clearance to allow the rear door of your 2008 Dodge Sprinter to open. It has a distance of 15 inches from it's hitch pin hole to the back of the bike rack mast which is more than enough. view full answer...
Eric, the Lippert Patio Upgrade Kit for Toy Hauler Garage Doors # LC27FR weighs 116 lbs; but for the railing kit, we do not have those parts, unfortunately. view full answer...
Hey Mark, the Lippert hinge kit part # LC198295 that you referenced is exactly what you are looking for. This is a 6-leaf hinge setup that is the non-friction style like you asked about as well. view full answer...
Hey Matt, it would be pretty difficult to install two of the ramp door springs part # 362SA7 at the same time so it's going to be best to just use the one. You most likely will find that you don't have to have it fully wound to get enough spring to make lifting the ramp easier but you could potentially wind it tighter at that point to get it to help lift even more. view full answer...
Hey Luke,
Sorry about the confusion, and we can 100% get your 2007 Honda Civic 4-door sedan set up with all the parts needed for a Rhino-Rack roof rack, including both crossbars. You would just need these parts:
- Rhino-Rack Vortex Aero Crossbars # RRVA126B-2
- Rhino-Rack 2500 Series Legs # RRRLKVA
- Custom DK Fit Kit # DK152
This will have all the parts needed and give you a rack with both crossbars so you can haul your gear. view full answer...
HI Mason; thanks for writing in, though the only color the Multi-Purpose Access Door w/ Lock # 372E8102-A comes in is White. That said, it is designed to be painted if need be, so getting a coat of black paint on it is something you can do pretty easily. view full answer...
Hey Kristopher,
Replacement parts for the Everchill RV Refrigerator w/ Freezer # 324-000119 will have to purchased through the manufacturer. Everchill recently sold to Lippert Components so if you give them a call they should be able to hook you up with the correct bins. view full answer...
Hey Geri, thanks for reaching out!
The Plunger and Nylon Socket Door Holder - 1" Long Plunger # DH604 is a pretty standard part so I'm pretty sure it will be exactly what you're looking for.
The mounting holes for the bracket have a 3/16" diameter and are separated by 1-1/4" on center. If this matches the bracket you have then you'll be good to go! view full answer...
Hey Robert, thanks for the picture. It looks like the exact hatch is the part # D04-0471BKVP which may be slightly modified. I would attach the picture you sent in but it looks like maybe it was from a video that might have been copyrighted. view full answer...
Hey Les,
The TorkLift SuperTruss Hitch Extension # TLE1536 you were looking at is exclusively for TorkLift's SuperHitch so you'd have to replace the factory hitch with part # TL74FR in order to use it. There are other hitch extenders available but they'll reduce the capacity of your trailer hitch by 50% and won't be nearly as long as the SuperTruss extenders. Do you know how long of an extender you need to clear the truck bed camper? view full answer...
Since you haven't bought the 2023 Kia Carnival yet and you are still in the shopping phase you should definitely go with one that has raised roof rails so you can install a roof rack like the Rhino Rack part numbers # RRVA137B-2 and # RRSX100 as there aren't any solutions for the naked roof configurations. view full answer...