Expert Answers about Mazda 5

Will I need to Drill the Frame on a 2010 Mazda 5 to Install Draw-Tite Hitch 24773
Draw-Tite hitch 24773 for your 2010 Mazda 5 does not require you to drill new holes, but you will need to enlarge two existing holes with a 1/2 inch drill bit. This is a much easier task than measuring for and drilling new holes. I have added a link to the instructions that come with the hitch for you to review.
view full answer...

Tongue Weight Rating of Trailer Hitch for a 2015 Mazda 5
For your 2015 Mazda 5 the Draw Tite hitch part # 24874 has been confirmed as a fit. The tongue weight rating of this hitch is 200 lbs. Which means it can handle 200 lbs of vertical weight at the hitch opening. A 700 lb trailer would most likely have a tongue weight right around 70 lbs. That being said, if the owners manual of your vehicle states that you can't tow with it there's nothing we can recommend for you that would allow you to do so. You can also check with a Mazda dealer to see...
view full answer...

How to Install a Roof Rack on a 2017 Mazda 5 with a Naked Roof
Take a look at the video I attached of the Yakima roof rack system being installed on a 2013 Mazda 5. About 20 seconds in you see the installer remove the black covers along the strips on the roof. Under these covers are mounting points for the roof rack to fasten to. The Yakima system that fits your 2017 Mazda and is similar to the system in the video consists of the 48 inch round bars # Y00408, SkyLine towers # Y53TR, adapters # Y03536, and landing pads # Y00248. This is my favoite...
view full answer...

What Is the Height of the Malone Profile 18B Rooftop Cargo Box?
From the lowest point to the highest point on the Malone Profile18B Rooftop Cargo Box # MPG911 it measures 15-3/4" tall. Any additional height from your crossbars would have to be added after the fact as we won't have that information. Seeing as though you only have 15-5/8" total of clearance I'd say it's safe to say that you won't be able to keep the cargo box installed when you park your car in the garage.
view full answer...

Which Hitch Should be Used To Tow a 1,000 Pound Water Craft Trailer Load
The hitches for a 2009 Mazda 5 can handle up to a 2,000 pound trailer load. You could use part # 11338 or part # 24773. Part 11338 comes with a drawbar and pin and clip. You will need to check the owner manual for the Mazda 5 to see what the maximum tow capacity is. It may be less than the hitches. You must always abide by the weight capacity of the lowest rated component whether that is vehicle or hitch. Of those 2 vehicles, I would tow with the Grand Am. It has a larger engine and is...
view full answer...

Bike Rack Recommendation for a 2007 Mazda 5
You have a few trunk mount bike rack options for your 2007 Mazda 5. I recommend The Thule Raceway Pro, # TH9001PRO. This is one of the top trunk mount bike racks on the market that has been confirmed to fit your vehicle. This bike rack has large protective support pads, road dampening cradles and 4 ratcheting coated steel to secure the bike rack to your vehicle. I have attached a review video for you to check out. If you plan on carrying any womens, childrens or alternative bike frames,...
view full answer...

Way to Carry 4 Bikes with 2012 Mazda 5
The only hitches for your 2012 Mazda 5 are Class I hitches which can only carry a max of 2 bikes at a time. This is because the hitch is lighter duty and can't handle the increased weight and leverage. The most economical solution would be to get a 3 bike trunk rack and then use a roof rack bike rack to carry the fourth. For a 3 bike trunk rack we have the part # TH78VR as a confirmed fit that would work well. I've linked the page to all your options. You'll have to install a roof rack...
view full answer...

Is a Hitch With a 2 Inch Receiver Available for a 2010 Mazda 5?
There are no hitches available for a 2010 Mazda 5 that have a 2 inch receiver. Each of the three available hitches, such as the Draw-Tite # 24773 have a 1-1/4 inch receiver and are Class I rated. The reason for this is that the Mazda 5 was not meant for towing or using anything but lightweight accessories which might necessitate a higher-rated hitch.
view full answer...

What is Need to Install a Hitch and Use a 2 inch Bike Rack on a 2006 Mazda 5 Sport Wagon
The installation hardware, nuts and bolts, are included with the hitches we sell. You can use an adapter like part # HTAD, but using an adapter like this will reduce the tongue weight by 50 percent. This would leave you with 100 pounds tongue weight capacity meaning the combined weight of the rack and all bikes on it must be less than 100 pounds. Also, if you use a Curt 1-1/4 inch hitch, a Curt stabilization strap, part # 18050, must be used for any non-trailer loads like bike racks or...
view full answer...

Roof Rack Recommendation for 2006 Mazda 5 with Fixed Mounting Points
Between the Rola, Inno, and Rhino-Rack roof racks you mentioned, I recommend sticking with the Rhino-Rack ROC25 # RR77MR. This rack will offer you the most streamlined look and will offer you the quietest ride. The aerodynamic shape of the crossbars in the ROC25 system combined with the way the crossbars end at the rack's feet are what help to quiet the ride with this rack compared to a more traditional-design rack, such as the Inno Square Bar # INB117, # INXP, # INTR120 rack. The DISCONTINUED...
view full answer...

Recommendation for a Bike Rack and Hitch for a 2007 Mazda 5 and Tips for Installation
The Draw-Tite Hitch, # 24773, and Swagman XTC 2 Bike Rack, # S64670, combination that you have suggested would be a great combination for your 2007 Mazda 5. Draw-Tite does not require the use of stabilizing straps on their hitches at this time and two 30 pound bikes and the 36 pound bike rack are well within the 200 pound maximum tongue weight limit of the hitch. You should check the vehicle owners manual to be sure you stay within the manufacturer recommendation for tongue weight. The...
view full answer...

Will The Draw-Tite Class I Trailer Hitch, # 24773, Fit Both A 2007 And 2009 Mazda 5
Yes, the Draw-Tite Class I Trailer Hitch, # 24773, will fit the 2006 to 2010 Mazda 5 vehicles, so it will fit both the 2007 and the 2009 models. The ballmount, pin and clip are included with this hitch. You will need a hitch ball like the Tow Ready 2 Inch Hitch Ball, # 19258. The wiring harness for your 2009 Mazda 5 would be the Tow Ready Wiring Harness, # 119176KIT. I am sending a link to the installation instructions for the trailer hitch and the wiring harness and a video link of...
view full answer...

Roof Rack and Cargo Box Recommendations for 2012 Mazda 5 with Fixed Point Mounting System
Yes, your 2012 Mazda 5 with the fixed-point roof mounting system can be equipped with the Rhino-Rack Vortex Aero roof rack system you referenced, parts # RRVA118B-2, # RRRLKVA and # DK285. All of the compatible rack systems we offer can be seen on the link provided. The other link provided will show you all cargo boxes we offer that fit elliptical crossbars such as those in the Rhino-Rack system. You can use the filters at the left-side of the page to narrow the results shown based on...
view full answer...

Parts Needed to Tow Small Trailer with 2015 Mazda 5
For your 2015 Mazda 5 the hitch part # 24874 is a confirmed fit as well as the trailer wiring part # 118520. The ball mount part # 3592 is correct for the hitch and for a hitch ball the # 19258 would also work well for a 2 inch hitch ball. I looked up the towing capacity of your vehicle and it is rated for up to 2,000 lb trailer weight so as long as your trailer and motorcycle end up less than that you'd be fine. California would not have any state specific restrictions on your vehicle...
view full answer...

Trailer Hitch for 2010 Mazda 5
I cannot speak to how vehicle manufacturers rate their vehicles in global markets, but here in the U.S. you are correct, the 2010 Mazda5 should not tow a trailer, as specified in the owner's manual. You can still put a trailer hitch such as the Draw-Tite # 24773 on the vehicle, but it is a Class I hitch that should be used for accessories such as bike racks or cargo carriers only.
view full answer...

Option for Carrying 4 Bikes with a 2012 Mazda 5
On a Class I hitch you should never carry more than 2 bikes with a hitch mounted bike rack. The reason is because of the additional weight and leverage of the additional 2 bikes would be too much for the hitch/frame and would most likely cause damage. I attached an FAQ on hitch classifications for you to check out. At this time there are only Class I hitches available for your vehicle (like the Curt Trailer Hitch # C11127 you referenced). However, you if you really need to transport 4...
view full answer...

Roof Rack Feet Compatible with Old Thule Cross Bars for 2008 Mazda 5
The Inno Feet for Square Crossbars # INXP will work with your older Thule square load bars. To fit on your 2008 Mazda 5, they would also need the Custom Fit Kit # INTR120. Those two parts will work together to make a complete set ready for your square crossbars. I attached a photo of it installed on a Mazda like yours. I don't know what your original Thule feet specs were, but the Inno Feet # INXP have a weight capacity of 165 lbs which is great as I have seen other roof racks in this...
view full answer...

Recommended Trailer Hitch and Related Items for Towing Utility Trailer with 2008 Mazda 5
Draw-Tite Class I trailer hitch # 24773 is a confirmed fit for your 2008 Mazda 5 and it installs without drilling using the included hardware package. I have linked a video, the written instructions and a helpful article on hitch installation to assist your install. Towing will also require a ball mount, pin and clip and hitch ball. The hitch comes with the ball mount and pin/clip so you'll need to add only a hitch ball of the size required to match the trailer's coupler, either 1-7/8-inch...
view full answer...

Replacement Lower Cover Strip Recommendation for a Thule Aero Blade Bar
Yes, you will need a Replacement Cover Strip for Thule Aerobar # 852-4498-001. This is a replacement lower cover for your Thule Aero Blade bar.
view full answer...

Hitch Availability for 2010 Mazda 5 for Using Hitch Bike Rack
All three hitches offered for your 2010 Mazda 5 are light-duty Class I hitches with a 1-1/4-inch receiver opening and a tongue weight rating of 200-lbs. Unfortunately no Class II hitches are offered for your vehicle. Class I hitches have a limitation on their bike carrying capacity - 2 bikes maximum, regardless of the bike rack's capacity. Please refer to the linked article for more details. Although the Thule Hitching Post Pro 4 Bike Rack # TH934XTR will fit a Class I hitch, only two...
view full answer...