Thank you for the picture. Unfortunately, there isn't going to be a hitch for the 2017 Ram ProMaster 3500 that is compatible with that step. Even something like the Draw-Tite # 75882 which hangs down a little bit further than the Curt # C13295 is going to have the receiver blocked slightly by the step on the rear of your ProMaster.
What you could do is remove the rear step and replace it with a hitch mounted step like the WeatherTech BumpStep Hitch-Mounted Bumper Protector and Step for... view full answer...
You would need to remove the bikes from the Hollywood Racks Sport Rider SE2 Bike Rack item # HR1450Z-85. Since this bike rack has the cargo carrier it doesn't tilt down as far as you will need to get clearance for doors that swing to the left and right. This bike rack isn't compatible with adapters either so you wouldn't be able to extend it our from your Promaster to get extra clearance. view full answer...
No, unfortunately the Thule Elite Van XT 2 Bike Rack for Ram ProMaster Rear Door # TH302013 will not fit if you have a ladder on the left door. That is because the platforms of this rack are too close to the van (especially when folded up) and there will be interference.
If you want to add a bike rack to your ProMaster the best way to do it would be with a trailer hitch. The etrailer Trailer Hitch Receiver # e99AR will fit your ProMaster and provide you with a 2" hitch receiver for a bike... view full answer...
Thank you for the photo. I can confirm for you that the WeatherTech Side Window Air Deflectors with Dark Tinting # WT80749 will fit on your 2017 Ram ProMaster 3500. I have sent you the installation instructions to take a look at as well. view full answer...
The Thule Elite Van XT 2 Bike Rack # TH302013 has a weight capacity of 42 lbs. per bike. This is the weight capacity when taking in consideration each component of the rack. Using bolts or screws would not change this weight capacity.
If you are needing a bike rack that can handle two 54 lb. bikes, you will need to use a hitch mounted bike rack like the Hollywood Racks RV Rider Bike Rack for 2 Electric Bikes # HLY64FR. view full answer...
Based on my research, the Thule Apex Swing TX # TH9027XT will allow the rear doors to partially open on your 2020 Winnebago Travato with a 2019 Ram Promaster chassis.
The distance from the center of the hitch receiver to the upright mast on the Apex Swing when fully swung out is approximately 33 inches and from what I was able to find online each door on your Promaster is just under 37 inches wide. Therefore, you will be able to gain decent access to the back of the van but you will not... view full answer...
The Edge Gas Evolution CTS3 Performance Tuner # EP99YR is the only tuner we carry for your 2014 Ram ProMaster 3500. This does offer different power levels for your 3.6L V6 engine with some seeing as much as a 2mpg increase. view full answer...
For your Empire Faucet set that uses the Flexible Spout-Quick Disconnect # EM94FR, we do have the Hose Extender for Empire Faucets Quick Connect Outdoor RV Faucets # EM64FR (15'). I know you mentioned not needing a 15' hose, but this hose does feature a coiled design. So it is not just 15' of hose spread out that you are having to deal with all of the time.
Another potential option would be the D&W Inc. RV and Marine Quick Connect Garden Hose Adapter # PF247007. This adapter was designed... view full answer...
I recommend the Roadmaster Spare Tire Carrier # RM-195125 for your 2023 Winnebago Travato 59KL. I have included a picture with this carrier on a Travato so you can see how it will fit past the bumper and ladder.
If you are wanting to use the Roadmaster Hitch Mounted Spare Tire Carrier # RM-195225 for its extra capacity you will also need a Passenger Tire Adapter # RM-195225-95 to fit your spare. Remember that using either of these will reduce the receiver capacity on your Travato by 33%.... view full answer...
Yes. The Roadmaster Rear Anti-Sway Bar # RM-1129-143 is a confirmed fit on the Class C Ram Promaster 3500 chassis and will be the correct part for your Winnebago Solis. view full answer...
The difference between the Thule HideAway Awning - Roof Rack Mount # TH490010 and Thule HideAway Roll Out Awning for ProMaster # TH620001, is that the # TH490010 is designed to mount to a Thule TracRac ladder rack or aftermarket roof rack. While the # TH620001 is designed to mount to the roof of a ProMaster or Sprinter cargo van.
Given that you have a ProMaster cargo van you will want to use the # TH620001. You will also need the Dodge ProMaster Van Adapter for Thule HideAway Awning TH620001... view full answer...
I can tell you how to determine the fit of the Advent Air Replacement RV Air Conditioner for Dometic Setup # ACDOM150 on your Roadtrek motorhome, but we don't have a way of knowing specifically what AC unit you currently have.
So you'll need to check the control center model number on your Dometic AC and if you have the Analog model number 3107541.009 and 3107541.017, or Comfort Control Center model number: 3109226.005 you can use the # ACDOM150. view full answer...
VanRug actually makes a version designed specifically for the 159 inch extended wheelbase version of your 2022 Ram ProMaster 3500 with the part # VRDP14LX which is the same charcoal color as the part number you mentioned. This for sure would fit your ProMaster well and would extend all the way to back of the cargo area of your Promaster. view full answer...
The Kuat Pivot # PVP20B is only rated for 2 inch bike racks because it extends the hitch point back further than your hitch receiver. 2 inch shanks are stronger than 1-1/4 inch shanks. The shank of a 1-1/4" bike rack cannot handle the added strain it'll endure when put into the pivot. The Pivot is not rated for Class A RV or camper use. Something like a Promaster Van or a Ford Transit will be okay though. The reason why it's not rated for Large RV/Trailers is because it will experience... view full answer...
The Thule HideAway Awning for ProMaster or Sprinter Vans part # TH620001 for 10' or part # TH64WJ for 12' are designed as a direct fit for Ram ProMaster 3500 Vans. They will use the existing mounts on the roof for a no-drill fit. They feature a manual operation. view full answer...
We have not yet had the chance to install the GearDeck 17 Enclosed Cargo Carrier for 2" Hitches - Slide Out - 17 cu ft - 300 lbs - Black # H00604 on a Ram Promaster however I am happy to provide you with some measurements. The GearDeck 17 sits 14" from the center of the hitch pin hole when in use and then when it slides, it will be 50 inches from the center of the hitch pin hole.
Another option would be the Yakima EXO Swing Away Enclosed Cargo Carrier # Y62VR which will swing completely... view full answer...
I have a solution for you but there is no way to attach the Thule HideAway Awning for ProMaster item # TH64WJ to the side of your Promaster 3500. Instead you will need to use the Roof Rack Adapters for Thule HideAway Awnings item # TH490001 to attach the awning to your roof rack crossbars.
The crossbars on your roof rack need to have a 36" spread and they can not be wider than 3-1/2". The adapter has built in locks to secure your awning from theft.
I have linked a picture below of what... view full answer...
Air bags will definitely soften up the rigidness of your rear suspension. I recommend the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers item # AL88233. This system has a 5,000 lbs maximum capacity and is adjustable from 5 psi all the up to 100 psi.
I also recommend the Air Lift WirelessAIR Compressor System for Air Helper Springs item # AL74000EZ. This wireless compressor allows you to fill your air springs at the touch of a button. The WirelessAIR also... view full answer...
Yes the Rhino-Rack Sunseeker Awning - Roof Rack Mount part # RR32133 will work out great on your 2019 Ram Promaster 3500. The awning has telescoping legs which extend up to 7' or 84" which will be perfect. It will give you a slight pitch to the awning which is always recommended for run off. view full answer...
Yes the Replacement Wall Control Panel for MaxxAir MaxxFan Plus Roof Vent # MA59FR is correct for the MaxxAir fan 00-07500K fan. The fan comes with an RJ11 style of wire that you'd run to the wall switch # MA59FR. view full answer...