The Gustafson RV Pancake Light, Item # 277-000340, has three settings: off, one light, both lights. Based on my research, dimming the lights is not an option. How many lights you need would depend on how much light you want in your van interior. I recommend going with 3-4 lights depending on your needs.
Contact us if you have any other questions. view full answer...
I am not really sure what you mean by "unnerving truck traffic vortex" but the previous issue you mentioned was side to side sway from passing trucks and if that is the case then the best option you have to reduce this will be with a rear anti-sway bar, the Roadmaster Rear Anti-Sway Bar part # RM-1129-143 which is correct for your 2019 Winnebago Travato 59K. The rear anti-sway bar acts as a link between the frame and axle to minimize the effects of side to side rocking otherwise know as... view full answer...
You would not be able to install camper steps such as LC678041 in your 2017 Ram ProMaster 2500 van, though we do have some options for you.
I recommend the Carr Slide-Out Step # CARR501090 to mount along the side of your van. It will stow beneath your van when not in use so you do not have to worry about taking up space along the inside of your van. view full answer...
For your 2018 Ram ProMaster 2500 the SumoSprings rear suspension kit you'll need is the part # SSR-313-54. This has the most support at 2,800 lbs which will be ideal since you will be converting your setup to a camper.
I'd first try it with both spacers. If you find the ride quality is too harsh then maybe take the one out, but I would be shocked if you didn't prefer the spacers. The springs are most likely going to touch all of the time due to the additional weight you are adding. view full answer...
There are nicer tire chains out there that will last a lot longer that what you experienced with the set you have now. The difference is that the metals used in the nicer chains is a harder metal that doesn't wear out as quickly.
If you wanted the nicest set that fits your tire size of 225/75-16 on your 2019 Ram ProMaster 2500 the Konig Easy Fit Chains part # TH04115245 will last a very long time, provide great traction, are self tensioning, and install in a matter of seconds.
Otherwise... view full answer...
Routing the power wire of the Tekonsha 7-way kit # 22112 on your 2021 Ram ProMaster 2500 is up to you. You can run it through inside of the vehicle interior or you can run it on the outside like we did in our install video. In our experience we found the outside routing to be easier so that would be what I would go with for you. I attached an install video for this for you to check out. view full answer...
You are correct. The Curt wiring harness part # C56209 that you referenced is the correct trailer wiring harness for your 2015 Ram ProMaster 2500 with a 159 inch wheel base. We confirmed this fit with Curt. view full answer...
There is not a version of the Thule TracRac TracVan ES Van Ladder Rack part # TH29613XT for your 2017 Ram ProMaster 2500 that comes with three crossbars so your only option to obtain this many would be to purchase two kits unfortunately. view full answer...
We have the Thule Hidewaway Awning part # TH490008 and # TH490001 which is designed to attach to roof racks like what your ProMaster has. Feel free to send pictures though and I'll verify this further if needed. view full answer...
Since you are loading your 2018 Ram ProMaster 2500 up to the GVWR I recommend starting off using the SumoSprings Solo Custom Helper Springs # SSR-313-54 for the rear axle. These are the heaviest duty option available which is what you need for your application.
If you had a passenger vehicle then I would say that the rear SumoSprings would be enough but since you have an RV I also recommend installing the Coil SumoSprings Custom Helper Springs # CSS-1195F. These will not only assist your... view full answer...
If your loaded tongue weight is 565 lbs then the Steadi-Flex part # RP66559 would work since it has a tongue weight range of 500-1,000 lbs. The part # RP66559 has a much narrower tongue weight range of 400 to 600 lbs and since you are pretty close to 600 you'd be best served going with the higher rated setup.
Also if needed you could always have spacers welded to sides of trailer frame for the additional width for the brackets. view full answer...
The SportRack Ridge Swing 4 Bike Rack # SR2415 referenced in your question will fit your 2016 Ram ProMaster 2500 as long as you have a 2 inch hitch receiver installed. When the bike rack is completely extended and swung to the side, there will be a distance of 36 inches from the center of the hitch pin hole to the upright arm. I recommend taking this measurement out to the side from the center of your hitch receiver to see if this will be enough space to allow the rear doors to open on... view full answer...
Easiest solution would be the 7-way adapter part # 37185. The 4-way he has already would plug into the adapter and you'd have a 7-way with the turn signal circuit active. view full answer...
There is a solution for you, but it may require drilling. Unfortunately, it will not be a traditional running board that fits your 2019 Ram ProMaster 2500 with the 136" wheelbase. I recommend going with the hoop steps, something like the Carr Custom-Fit Side Step - Hoop II - Black Powder Coated Aluminum - 7" Step - Qty 1, part # CAR89MR. This will fit your vehicle.
I have included a product description link below. view full answer...
The best roof tent for your 2017 Ram ProMaster 2500 is the Yakima SkyRise HD Tent for Roof Rack Crossbars - 2 Person # Y07436. To mount this you will need a roof rack; I recommend going with Rhino-Rack Vortex Aero Crossbars - Aluminum - Silver - 71" Long # RRVA180S-2. You will also need Rhino-Rack RLTP Legs # RRRLTPFD and RLTP Leg Adapters # RRVA-FK1-2 to install the crossbars. This has a weight capacity of 165lbs, which is the highest weight capacity of any roof rack for your vehicle.... view full answer...
In order to install a 7-Way trailer connector and brake controller on your 2014 Ram ProMaster 2500 you will need a couple of items.
First you will need to install a wiring harness which will end up being part of the 7-Way connector installation. For that, yes, you can use # 22112 which also comes with the wiring needed to install a brake controller.
The only other part you will need is the brake controller. For a brake controller I recommend the Redarc Tow-Pro Elite # RED44FR because... view full answer...
The # FLX400008 you looked at will fit your 2016 Ram ProMaster 2500. However, it is a bit on the small side. I would choose something larger like the Derale Series 8000 Plate-Fin Transmission Cooler # D13503. A good rule of thumb is to add the largest cooler that will fit. Assuming we stick with a plate and fin design this matches that description. Unlike the Flex-a-lite, this also comes with a 1-year warranty.
I have attached an installation video below for your reference. view full answer...
For your 2018 Ram Promaster 2500 the Draw-Tite Max-Frame Trailer Hitch Receiver # 76050 that you referenced is a confirmed fit and has a tongue weight capacity of 500 lbs which you could use with a motorcycle carrier like the Ultra Fab part # UF48-979033 which has a ramp and a 500 lb capacity as well. The weight of this carrier is 50 lbs so you'd need to consider that as well. view full answer...
Your best option for your Knapheide KUV Body is to use an RV hitch that can bolt on as there are not custom fit options for your application from any of our manufacturers due to the extended wheel base. I recommend the Adjustable Width Trailer Hitch Receiver for RVs, 18" to 51" Wide # C13702 or the 2 inch drop # C13701. view full answer...
Go To Results