The SumoSprings Solo Custom Helper Springs item # SSR-307-47 have a 1500 lbs capacity whereas the SumoSprings Solo Custom Helper Springs item # SSR-307-40 have a 1,000 lbs capacity for lighter towing and hauling applications. Both are designed to offer a stable ride when your 2019 Ram 1500 Classic is loaded down or towing a heavy load. The SumoSprings are by far the most ride comfortable jounce style springs available. There would be minimal difference if any at all when unloaded. They... view full answer...
I went ahead and reached out to my contact at DK2, and he said that you are correct in saying that you will have to remove the air dam on the bottom of the bumper of your 2019 Ram 1500 Classic in order to install the mounting brackets # K284314 on a DK2 snow plow like # K2STOR8422.
When it comes to removing the air dam brackets, my contact unfortunately could not confirm for sure whether the brackets need to be removed. With that being said, the best route forward is to see if you can... view full answer...
The etrailer hitch part # e98852 is a confirmed fit for your 2019 Ram 1500 Classic that does not have a factory hitch and has more than enough towing capacity so it would work great to tow a 4,000 lb travel trailer. Since you already have a weight distribution system and wiring the only other thing you'd want is a brake controller to activate the brakes of your trailer to help stop the trailer.
For that the Brake EVN # TK63VR would be a really great option and would only require the install... view full answer...
The bolts on the Husky Center Line Weight Distribution w/ Sway Control part # HT32215 should definitely be torqued. However you do not need to torque them yourself. They will be preset from the factory. If they are stiffening up use a good lubricating spray to free up the joint. It is likely some corrosion has creeped in there causing your issue. view full answer...
I checked with LaSalle Bristol for info on how the fittings you mentioned connect of the # 34420380R340NABX and they send me the following:
The spout sleeve has a lip that needs to be inserted into the channel on the spout.
Once that is in place the spout will tightly fit into the faucet deck. view full answer...
The Draw-Tite Activator IV Trailer Brake Controller part # 5504 will not turn off as soon as the vehicle is turned off. The Draw-Tite Activator IV like most trailer brake controllers will go into a sleep mode after about 15 minutes of inactivity. The controller will never lose power completely but after the set time has expired the display will go blank. That said, if you open the door that would trigger the system to awake so if you want to check you simply need to peek in through the window. view full answer...
The DeeZee Custom-Fit Truck Bed Mat part # DZ86917 is very good about staying in the bed of the truck with no additional help. It is a 3/8" thick mat that's quite heavy and there are no issues with it catching air and flying out.
You can certainly use some double sided tape if you want but generally it is not required. The other mats that you see including the tape are very light weight and generally do need the tape to stay in. view full answer...
Have no fear! The DeeZee Tailgate Assist Custom Tailgate Lowering System # DZ43301 is the correct kit for your 2019 Ram 1500 Classic and the new bottom plate that was included is supposed to be there. DeeZee recently added this component in place of the single ball mount not because of a difference in the truck but simply to allow for a sturdier connection. The new bottom plate is designed to create a more durable overall system with a longer lifespan.
I have attached an image of the... view full answer...
The etrailer Trailer Hitch Receiver # e98852 is a fit for your 2019 Ram 1500 Classic, so you do have the right hitch for your truck. It is rare that the bumper cap can't go back on easily, but the space between the cap and your bumper is definitely evident in the photo you sent.
What has worked for some people is to try re-installing and changing the order in which you torque down the bolts to get the hitch to seat a little bit differently and allow the cap to sit down. You can also try... view full answer...
The Air Lift 1000 Heavy Duty Air Helper Springs for Coil Springs part # AL60818HD are a great option for a 2020 Ram 1500 Classic. If you want to control both air bags together then you'll just need a tee like the Air Lift Union Tee for 1/4" Air Lines part # AL21838. It will be better in the long run to install a tee if you're just using the air bags for towing. view full answer...
In regards to driving with a snowplow like the Detail K2 Rampage II Elite Snowplow part # K2RAMP8219ELT which is a fit for a 2019 Ram 1500 Classic using the Custom Mounting Brackets for Detail K2 Snowplows part # K284314, you'll need to check with your local state offices for rules and regulations as they can be different for each state/county. The only issue I can see with this would be blocking the headlights and in which case you could just use the Halogen High/Low Beam Light Kit with... view full answer...
I'd be happy to help you with that.
I'd recommend a proportional controller, which can sense how quickly the tow vehicle is braking and will then send the appropriate amount of voltage to the trailer brakes so the trailer and the tow vehicle brake at the same rate for safe, reliable and predictable braking. The Tekonsha Prodigy P2 you'd looked at, part # 90885 would be a great choice. You'll also need the # 3024-P wiring harness which plugs into the connector located just above where the... view full answer...
The rails on the Reese Quick-Install Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches Item # RP50142-58 should be placed from center to center 22" apart. view full answer...
I spoke to my contact at Redarc and they said that the Redarc The Manager30 # RED93FR can work in a trailer when not attached to the vehicle. The shore-power will go through the charge and convert to DC power to charge the batteries. The solar will do the same. The solar and shore-power can be hooked up at the same time. The Manager30 will draw from the solar panels before taking shore-power.
Your 2019 Ram 1500 Classic 6 cylinder may have issues towing your Jayco trailer. My research... view full answer...
The Westin E-Series Bull Bar with Skid Plate - 3" Tubing # 31-5965 is confirmed to fit your 2022 Ram 1500 Classic. I went ahead and attached the installation instructions. There is trimming required for installation.
If you need a license plate relocation kit, that is part # 32-0055. view full answer...
You sure won't, except for the tape that covers the mounting holes on the back of the rocker panels. Other than a few pieces of tape, nothing existing will need to be removed. If you use the provided link, you can see a product description video for the Westin Platinum Nerf Bars. view full answer...
The Go Power Eco Solar Charging System # 34273836 can be connected to more than 1 snowmobile battery but you would need to make sure that your batteries are connected in parallel for 12 volts so that the voltage of the batteries don't change. This solar panel kit only provides a trickle charge so you need to make sure that your batteries are completely charged prior to hooking this up via a charger/maintainer like the NOCO # 329-GENIUS10 which allows you to connect up to 4 individual batteries... view full answer...
I checked with Pop & Lock for you and for your 2019 Ram 1500 Classic, you do need to run the wires to the driver's side kick panel when installing the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers # PAL9772. view full answer...
Yes, you can use the Tekonsha Plug-In Wiring Adapter # 3024-P to simply plug-in the Prodigy P3 # 90195 for installing it on your 2019 Ram 1500 Classic. Please note that since you have the Classic version of the 2019 Ram 1500 your pickup is the same as the 2018 Ram 1500 so it doesn't make sense as to why you wouldn't be able to install an aftermarket controller on your pickup.
The installation will be the exact same as it is on the attached video of this on a 2017 Ram 1500 which I have... view full answer...
The Flint Hill Goods Bug Deflector and Hood Protector # FHG99FR has mounting screws that will thread into the existing holes for the hood's weather-stripping so that you won't have to drill holes. view full answer...
Go To Results