It sounds like the ball mount you have might be a Class II ball mount. The 1-1/4 inch size receivers come in two classes, Class I which is rated for 2,000 lbs. towing and 200 lb. tongue weight and Class II which is rated for 3,500 lbs. towing and 350 lbs. tongue weight.
To keep a user from overloading a Class I hitch, Class II hitch accessories, such as ball mounts and several bike racks and cargo carriers, are designed to not fit. Manufacturers accomplish this by placing a stopper in... view full answer...
You should have no problem using the Thule Gateway Pro 2 Bike Rack, # TH88VR, on your 2004 Nissan Sentra SE-R Spec-V. This bike rack is designed to fit over the factory spoiler and uses 6 straps to secure the bike rack to the top, side and bottom edges of your trunk. The lower arm of this rack will sit on the top of your rear bumper.
I have attached a review video of this bike rack for you to check out.
If you plan on carrying any women's or children's bikes, then I would recommend you... view full answer...
To install a trailer hitch and wiring on your 2022 Nissan Sentra S I recommend the following:
- Curt Trailer Hitch Receiver # C11349
- T-One Vehicle Wiring Harness # 118582
The 2" receivers are definitely better since they work with more accessories, but unfortunately at this time (September 2023) there are only Class I hitches with the 1-1/4" receiver available for your vehicle.
If you plan on doing some towing with this setup I've linked our helpful article on choosing a ball mount... view full answer...
The Titan Chain Cable Snow Tire Chains # TC1034 will fit the 205/55-16 size tires on the 2014 Nissan Sentra. These cables will help provide traction in light snow and the low profile will offer a smooth ride.
The Sentra's owner's manual requires that Class S chains be used, and the # TC1034 cables comply with that requirement. Per the owner's manual, chains or cables should only be installed on the front wheels.
Rubber adjusters are recommended to use with these cables. I recommend... view full answer...
The Thule Passage Trunk Mount 2 Bike Rack # TH910XT will fit your 2012 Nissan Sentra with the factory spoiler. I have included a review video for this product and as well as installation instructions. Another plus for this bike rack are the cushioned anti-sway cradles that prevent bike-to-bike and bike-to-vehicle contact and include rubber straps to secure bikes in place.
If you intend to carry womens or childrens bikes that do not come equipped with a horizontal bar, I recommend the Thule... view full answer...
The transmission coolers we offer for your 2007 Nissan Sentra 2.0L are intended to supplement the cooling action of the OEM transmission cooler, but not to replace it. For example, we offer the Derale # D13503, which is a high-efficiency Class III cooler that measures 11 wide x 8-3/4 tall x 7/8-inches deep and which is shown in the linked installation video. This and other cooler options are shown on the link at right.
You can install as large a cooler as you have space available for it;... view full answer...
As long as your 2012 Nissan Sentra is equipped with a factory spoiler, you should have no problem using the Thule Passage Trunk Mounted 2 Bike Carrier, # TH910XT. The Passage mounts securely to your Nissan Sentra with the patented FitDial adjustment system and straps.
Here are a few tips that can considerably reduce the risk of damage to your vehicle when using a trunk mounted bike rack. 1) Make sure the surface of the rack and vehicle are clean and free of any debris. A good coat of... view full answer...
The Draw-Tite Sportframe Trailer Hitch Receiver # DT48MR is confirmed to fit your 2022 Nissan Sentra SR. The S is the only trim level of your Sentra that the receiver will not fit. Draw-Tite recommends using their Drawbar # 3593 in the rise position with either a 1-7/8" Ball # 19256 or 2" Ball # 19258 to match your coupler.
I recommend adding the T-One Vehicle Wiring Harness # 118582 when you install the receiver. This will allow you to connect to small trailers with a 4-way flat connector... view full answer...
We sure do! What you are needing is the MORryde cushioned pin box replacement for the Lippert Rhino, and the part number RPB77-FD-06 is for 18,000 lb to 21,000 lb trailers. The pin box you are looking for is the following:
- MORryde Cushioned 5th Wheel Pin Box for 18K to 21K Trailers w/ Lippert Rhino # MR55QR
The # MR55QR is a really nice choice because its rubber spring is going to absorb shock and dampen vibration, which will help give you a much smoother, quieter ride while you tow. view full answer...
The Hollywood Racks Express # HRE3 should not be used on vehicles with spoilers like on your 2006 Nissan Sentra but the Thule Passage 3, # TH911XT, should not have any problems fitting over the spoiler on your vehicle.
If you will be carrying any bikes that do not have a top frame bar that goes straight across (like a typical mens bike would) then I recommend using bike adapter bar # HRBA-PRO. This will allow you to carry those bikes more level and will provide better ground clearance.... view full answer...
There is a drawbar with 5" of rise that will work for you, but Draw-Tite # 36065 is for use with Class II hitches only, and is not compatible with your Class I hitch, # 24794.
Instead, you could use the Curt # C45024, a Class I draw bar which also gives you 5" of rise and will have no problems clearing your bumper with a length of 9-9/16". For a hitch pin you would want # F-4, and the hitch ball you want would either be 1-7/8" ball # C40001 or 2" ball # C40018. view full answer...
I am not certain what trailer hitch you have on your 2014 Nissan Sentra but the Curt Cargo Carrier # C18100 you referenced will only fit 2 inch trailer hitch receivers. This is an issue because the only hitches available for a '14 Sentra are Class I hitches with 1-1/4 inch receivers.
It is likely you actually have a Class I hitch with a 1-1/4 inch receiver like the Draw-Tite # 24907 and I strongly recommend making sure you know the exact hitch on your Sentra.
For a Class I hitch you... view full answer...
I checked with Hollywood Racks and the Express 3 Bike Rack part # HRE3 that you referenced is will not work on your 2005 Nissan Sentra because it has a spoiler. Instead, I recommend the Thule OutWay # TH56BV for your Sentra with a spoiler. The OutWay is the easiest rack to install and fits most facotry spoilers. Check out the attached video for this rack.
If the OutWay is out of your budget, I would next suggest that you look at the Thule Gateway Pro 3 # TH78VR. It also works with... view full answer...
The Draw-Tite Class I Receiver Hitch, part # 24750 is only compatible with 2000-2006 Nissan Sentra models. It is unfortunately not compatible with a 2000 Honda Accord.
These hitches are custom designed for a specific vehicle model year or range of model years.
You can find links to the installation instructions for each hitch below. view full answer...
Snow chains are typically rated for speeds of 30 to 40 mph.
The Thule CG9 Snow Tire Chains, # TH2004205080, is a top rated snow chain from Thule for your 2009 Nissan Sentra. It has the self-tensioning feature which allows easy installation and the chains will tighten and self-center on the tire as the vehicle is moving.
Always consult your owner's manual for any limitations or restrictions on the use of tire chains. view full answer...
The 4-Layer Deluxe Car Cover for Compact Cars by Classic Accessories, part # 052963710021, is designed specifically for compact cars. It is not matched specifically to vehicles, however, the Nissan Sentra would be classified as a compact car, so it should fit without any problems. view full answer...
I checked with Draw-Tite and they show the Draw-Tite Sportframe Trailer Hitch Receiver part # DT48MR as a fit for a 2021 Nissan Sentra SV. It will work great with any bike rack that has a 1-1/4" shank like the Thule Bike Rack part # TH934XTR which is what I recommend if you don't already have one. view full answer...
The new Thule AeroBlades are less then 4 inches in diameter so the mounting hardware on the SportRack Vista XL cargo box, # SR7018, will fit them. The center to center distance between the bars will have to be 25-7/8", 27-7/8", or 29-7/8". I have included a link to a video featuring the cargo box for you. view full answer...
The mounting hardware on your Karrite Scorpio cargo box will need to be able to fit on bars that are 3-1/8 inches wide and 1-1/8 inches tall to be able to mount to the Thule WingBars # TH711400 or # TH711420. And the box hardware will need to fit a bar spread (center to center distance between the bars) of 27 inches.
If the box fits that description then it will fit he Thule rack. In addition to the bars, to mount them to your 2010 Nissan Sentra you will need foot pack # TH480R, and custom... view full answer...
The Draw-Tite # DT48MR will indeed fit your 2021 Nissan Sentra SR, and actually the SV models as well. Though there will be drilling required for the installation, as with all hitches for your vehicle, the included instructions will lay out what needs to be done in detail.
If you were planning on towing with your Sentra SR, I recommend also installing the Tekonsha T-One Vehicle Wiring Harness with 4-Pole Flat # 118582. This is mostly a plug and play harness, but you will need to run one... view full answer...
Go To Results