Expert Answers about Lexus

• How Tight Should Wedge Be On Lippert Turning Point Pin Box to Hitch Jaw
• 3/16 of an inch is a solid amount of gap that's not too lose and not too tight. Basically you wanted as tight as you can get without causing it to become difficult to connect or disconnect so what you are doing now seems to be correct from what I am reading.
  view full answer...


• Towing A 2009 Ford Ranger 4x4 5 Speed Manual Transmission
• The neutral tow kit you're looking for was a Ford product that would've had to be purchased directly from Ford. Since the kit has been discontinued your safest bet is to trailer tow your 2009 Ford Ranger. If you need straps to tie down your truck I recommend the ProGrip Reversible Ratchet Tie-Down Strap - Double-J Hooks - 2" x 40' - 3,333lbs Item # 317-310800. If you want to dolly tow you'll have to remove the driveshaft or install a driveshaft disconnect to avoid damaging your transmission...
  view full answer...


• Is Weight Capacity of Hollywood Racks Trail Rider Per-Bike or Total
• The weight capacity is per-bike as opposed to total weight for the Hollywood Racks bike rack you mentioned: - Hollywood Racks Trail Rider Bike Rack # HR200Z So that means each side of the rack is rated for a maximum of 45 lbs per bike as opposed to the entire capacity being 90 lbs. You could use this bike rack if you wanted to with your 52 lb electric bike, so long as you removed your battery. If removing your battery doesn't get you under the 45 lb limit, then there is another option...
  view full answer...


• Does Stealth Hitches 391KIATELL20T Use The Standard Factory Mounting Holes On 2021 Kia Telluride?
• The Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit - Custom Fit - 2" # 391KIATELL20T you were looking at for your 2021 Kia Telluride uses the same frame mounting holes to mount the receiver that the other trailer hitch receivers use. The # 391KIATELL20T is a fantastic option for your Telluride since you can completely remove the ball mount or receiver when not in use so you will not see the hitch when not in use, and the included lock will keep them from getting stolen when...
  view full answer...


• Can You Mount 2 Malone SeaWing Kayak Carriers
• I doubt you will be able to use two on the roof at the same time but measure to ensure. The Malone SeaWing Kayak Carrier with Tie-Downs, # MPG107MD is just under 28" wide. If you mount this as close to the outside of your vehicles crossbars as possible, I think the inside edge of your kayak will be about 20 inches inboard. I think you will need about 40" between the mounting points of your crossbars to even consider using two. I suggest using the Yakima BigStack Roof Mounted 2 Kayak...
  view full answer...


• Which Bike Rack Should I Use For 2 Beach Cruiser Bikes?
• It looks like most beach cruiser bikes have fenders and/or baskets, both of which would interfere with the way that the Kuat Sherpa 2.0 2 Bike Platform Rack # SH12G attaches to the bike's wheel. You will want to go with a frame-mount bike rack; for this I recommend the Thule EasyFold XT Bike Rack for 2 Electric Bikes - 1-1/4" and 2" Hitches # TH903202. It attaches to the bike's frame, making it compatible with bikes that have fenders or baskets. The weight capacity is 65lbs per bike and...
  view full answer...


• Where is The Wiring For Brake Controller On a 2019 Jayco Seneca Freightliner Chassis?
• To install the Tekonsha Prodigy P3 Trailer Brake Controller # 90195 in your 2019 Jayco Seneca on the Freightliner S2RV chassis the wiring is behind the kick panel in the drivers compartment. There is not a connector on the wires, they are simply terminated with tape. You will connect those with the wiring pigtail that is included with the brake controller. You can use the longer Pigtail # 7894 if you wish to move the brake controller to the right side of the steering column. This pigtail...
  view full answer...


• Heavy Duty Powered Jack Recommendation for 2002 Carson Toy Hauler
• The Phoenix Electric Trailer Jack part # UF38-944055 would be an excellent option for your toy hauler as it has the highest capacity at 5,500 lbs and is also the fastest moving jack out there as it can move 6 inches in 18.4 seconds! I attached an install and review video for this for you to check out as well.
  view full answer...


• Reese Strait-Line Weight Distribution System for 10K Travel Trailer
• The Reese # RP66075 Strait-Line wieight distribution system is designed for trailers with a fully loaded and ready to tow tongue weight between 1000-1700 lbs. Given the likely tongue weight of your trailer, this system would be ideal. The system is designed for use with a 2-1/2 inch receiver, so the separately available shank should be compatible with a 2-1/2 inch receiver. I've linked to our selection of 2-1/2 inch receiver compatible shanks. I've linked to a product description video...
  view full answer...


• Tires & Wheels for 86 Jayco Pop Up with 2.75 Pilot Hole & Wheel Bolts
• There may be a solution but I do not have 8” or 10” wheels with 2.75” pilot holes. They are all 2.5” pilot holes. I have 12” wheels with 2.84” pilot holes. For example, Kenda # AM30790 is a 5.3 X 12” trailer tire with a 2.8” pilot hole, load range C and 65 mph. Kenda # AM30780 is a 5.3 X 12” trailer tire with a 2.84” pilot hole, load C, 65 mph. Kenda # AM3H370 is a 205/65-R10 trailer tire with a 2.5” pilot hole, load C and 81 mph. If you were using lug nuts (instead of bolts) then only...
  view full answer...


• Stowmaster Tow Bar Compatible Base Plate Kit for 2020 Jeep Grand Cherokee
• By brackets, I'm assuming you're meaning base plates that install on the vehicle and provide an attachment spot for the tow bar. If that's the case, I'd recommend the Roadmaster # RM-521440-4 which is compatible with all models except for SRT-8, Trackhawk and models equipped with a brush guard. Tow hooks, if present will need to be removed and left off the vehicle. This is an EZ4 style base plate which is compatible with the # RM-501 Stowmaster tow bar. In addition to the tow bar and...
  view full answer...


• Will Draw-Tite Trailer Hitch Receiver Install On 2021 Toyota RAV4 The Same As 2020 Toyota RAV4
• I confirmed with Draw-Tite and there we no changes between the 2020 and 2021 Toyota RAV4 regarding the installation of the Draw-Tite Trailer Hitch Receiver # 36675. The video that I attached of the Draw-Tite # 36675 being installed on a 2020 Toyota RAV4 will be able to help you simply complete the installation. If you can tell me what you are planning on using your trailer hitch receiver for I would be happy to recommend the best products for your needs.
  view full answer...


• Do 2015 Chevy Silverado 2500 and 2016 Silverado 3500 Use Same B&W Turnover Ball Gooseneck Hitch
• The 2015 Silverado 2500 and the 2016 Silverado 3500 can indeed use the same center section and rail kit according to B&W, so you will be able to transfer your existing hitch to your new-to-you truck. If the 2016 Silverado 3500 doesn't have a 7-way trailer connector installed in the truck bed, you can install one using part # 50-97-410. I've linked to installation videosthat you might find helpful.
  view full answer...


• TLA8103 Fitment on my 2018 Forest River Salem Cruise Lite 263BHXL
• Yes the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear part # TLA8103 will work out well for you. Your entry height is right at the minimum meaning you will have shorter steps which is what you are looking for. You are likely closer to the 28-30" range because they go from the bottom of the door rather than the top of the step bracket itself. . They are also quite easy to operate when compared to a standard steel step. I have linked a video for you on them to check out if you...
  view full answer...


• Which Stealth Hitches Trailer Hitch Receiver For 2021 BMW X3
• The Stealth Hitches are definitely a top of the line trailer hitch receiver that hides the trailer hitch completely when it is not in use on your 2021 BMW X3 due to the hidden crossbar design and removeable receiver opening, but you will need a different model hitch as the Stealth Hitches Hidden Rack Receiver # SH34VR you were looking at is only for the 2019-2021 BMW 3 Series Sedan. For your 2021 BMW X3 there are two different Stealth Hitches depending on the model of your X3. If your...
  view full answer...


• Will This Fit A 2011 Ridgeline 4 Wheel Drive?
• The Coil SumoSprings Custom Helper Springs for Coil Spring Suspension # CSS-1168R is designed to fit the rear axle. If your 2011 Honda Ridgeline is four wheel drive, that's fine but these are not designed to go on the front suspension.
  view full answer...


• Kuat Sherpa 2.0 Rear Window Visibility With My 2020 Toyota Prius
• The nice thing about the Kuat Sherpa 2 # SH12G is it has no center mast. So there will be less visual interference with your rear window. It will all come down to the bikes. The bikes are going to sit around 4 inches higher than your hitch receiver so you can get an idea of how much they will block your view if you hold your bike up 4 inches higher than your hitch receiver. I've included a picture of the Sherpa with bikes loaded on a smaller suv to give you an idea. The bikes are rather...
  view full answer...


• Can Air Bags be Used in Conjunction with the Anderson Weight Distribution System
• The Firestone Ride-Rite Air Helper Springs part # F2582 is an excellent way to help support the rear end of your 2019 Ford F-150 4x4. While the weight distribution helps to level the truck back out the air bags can also help with this taking some of the tension off of your system making it easier to set up. An additional benefit is in the wear and tear the bags will take off of your rear suspension.
  view full answer...


• Will # TX259101-CVR Fit My 2005 Ford F-150 STX SuperCab RWD With A 6.5 ft Fleetside Bed?
• Part # TX259101-CVR is actually the replacement part for theTruXedo TruXport Soft, Roll-Up Tonneau Cover # TX278101 which is confirmed to fir your 2005 Ford F-150 STX SuperCab with a 6.5ft Bed Excluding Stepside. I've included a review video of the tonneau cover so you can get a closer look!
  view full answer...


• Weight Distribution Hitch for 6,000 lb Travel Trailer and Will SumoSprings Reduce Tongue Weight
• SumoSprings will not affect the tongue weight for the weight distribution hitch, and I can help you decide the best hitch. In order to choose the best weight distribution system you will first need to know your total tongue weight (TTW), which is the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your F-150. The tongue weight is typically between 10% and 15% of your trailer's GVWR but you'll want to verify it by using a...
  view full answer...