I may have a solution for you, but according to my contact at Yakima the Spare Tire Carrier # Y07076 is not compatible with the Basketcase and there is not a tire carrier that will fit on the smaller bars. With that said, you could just use some ratchet straps like the CargoBuckle Mini G3 Retractable Ratchet Straps - 1" x 6' - 466 lbs - Qty 2 # IMF111640 to secure your spare tire. These ratchet straps will provide a bit more secure solution than the cargo net that was included with the... view full answer...
I have another option for you, but I do not have any information on which products, if any, will fit your 2012 GMC Yukon XL Denali with the auto leveling air suspension if you remove it as it is possible there are still other slight changes that would cause the Timbren suspension enhancement you mentioned to not fit.
Instead I recommend going with a weight distribution hitch which is the best way to prevent suspension sag on vehicles towing a travel trailer, and is recommended anytime... view full answer...
If you're wanting to install an AC unit with a heat pump on your box truck I recommend the Advent Air RV Air Conditioner w/ Air Distribution Box, Start Capacitor, and Heat Strip - 13,500 Btu Item # ACM135CH. This unit comes with an air distribution box that has a built-in thermostat, a start capacitor to help jumpstart the AC so you won't need as high of a starting wattage, and an electric heat strip to keep you warm in the winter.
This unit weighs approximately 100lbs so you'll need... view full answer...
The WeatherTech Cargo Liner part # WT40440 is a great option for a 2021 Toyota 4Runner with Double Decker Cargo System. It will cover the entire area of the tray and allow it to slide out with the liner in place. There are cargo liners that will cover the rear seats while folded down but this is not an option for models with the Double Decker Cargo System. view full answer...
Yes, since you have 29-30 inches of crossbar space on your 2017 Subaru Crosstrek's factory crossbars, you will have enough room to carry 2 Thule ProRide XT # TH598004 bike racks on your roof. In order to make this work, you will most likely need to install one rack backwards so that the handlebars of your two bikes do not interfere during mounting or transport. view full answer...
For a threaded Swagman hitch pin that can be used on a 3 inch receiver I recommend using the Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks # S64029, which has a usable span of 4-3/8" that will be enough to span the outside of your Ford F-250's receiver. This is a locking anti-rattle hitch pin, but it is the only threaded Swagman hitch pin that is long enough for this particular application. view full answer...
I recommend having a 2" to 1-1/4" hitch riser built for your Yakima Dr. Tray Bike Rack. Having a custom built riser will allow you to move the rack up for better ground clearance and keep it as close the the rear of your vehicle as possible.
The Curt Solid Steel 2" Hitch Bar # D31 can be welded to the 6" Combo Bar 1-1/4" Receiver # E-911 with some steel plate or tubing. A local welding shop should be able to provide the additional material necessary to get the receiver tube where you... view full answer...
With a 600 lbs tongue weight on your travel trailer, I recommend the # FA92-00-0800 Fastway e2 Weight Distribution w/ 2-Point Sway Control. This system is for a tongue weight of 400-800 lbs. Since you are at 600 lbs that puts your tongue weight right in the middle of the range which is ideal when using weight distribution. This has a bolt on installation so no drilling is required.
As for heavy duty shocks and adding a leaf to your leaf springs, we do not carry shocks or an add-a-leaf... view full answer...
Weathertech has an under seat truck storage box part # WT4S005 that fits your 2021 GMC Sierra 3500 crew cab but the part # WT4S002 does not fit. view full answer...
The Thule HideAway Awning - Roof Rack Mount - Waterproof - 80 sq ft # TH490010 can be mounted on your 2016 Mercedes-Benz Sprinter 2500. To mount the awning you will need the Roof Rack Adapters for Thule HideAway Awnings - TH490008 and TH490010 # TH490001.
I have attached a video of the installation and review of the Thule HideAway Awning. view full answer...
Based on the replacement 7-way kits we offer for your 2012 Honda Ridgeline like the Tekonsha part # 118253 we can confirm that the Hopkins Smart Hitch Backup Camera and Hitch Aligner System # HM50002 does for sure fit your vehicle.
We've had a few people report that water got into the back of the camera and that using an RTV sealant they were able to keep the water out of it going forward. That's what I would recommend for you.
I attached a review video for more info on this as well. view full answer...
Sorry to hear about your vehicle! The size wrench needed to remove the mounting hardware of the Rhino Rack cargo basket part # RMCB is an M6. I'd bring a metric set of allen wrenches though since pulling out a single allen wrench is a good way to end up losing it. view full answer...
The Malone SteelTop Roof Rack # MPG201 that you referenced has a dynamic capacity of 165 lbs which is different from the capacity needed for a roof top tent as that would be static weight. Dynamic in this situation means the capacity it can carry while on the road which will have bumps and dips that will exaggerate the weight on the rack.
So the standard way to determine if you'd have the capacity needed will be to contact the roof top tent manufacturer as they normally have a formula... view full answer...
I have a really great bike rack solution for you, but the Kuat Transfer V2 # KU84FR can only fit bike tires that are up to 3 inches in width.
So instead, I recommend the Lets Go Aero V-Lectric FAT PRO Bike Rack for 2 Electric Bikes - 2" Hitches - Wheel Mount # LGA77FR. This is fifth wheel approved like you need, has higher weight capacities need for e-bikes of 75 pounds per bike. It has wheel hoops that were designed for fat bikes that will accommodate tires up to 4.5" so that will also... view full answer...
Everything I was able to find on your 2007 Ford Ranger 2WD manual transmission is that it is flat-towable. Also worth mentioning is that the owners manual for the vehicle is the final word on this matter. If the owners manual says it's fine then you are totally fine. First thing you'll need is a base plate kit like the Roadmaster Crossbar kit part # 477-5 so you are definitely on the right track.
In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting,... view full answer...
Yes, the Trailair cushioned pin box # UF35-946212 that you referenced is the correct fit for you as this is designed to replace the Fabex 770 that you have now along with a few other variations. This actually fits the following:
Fabex 750, 765 and 770
RBW 7028 view full answer...
The arm of the Sidewinder part # RP34FR weighs approximately 145lbs and the turret weighs approximately 60lbs.
This will all come assembled as one piece though. view full answer...
For as trashed as those brake assemblies are I am impressed with how spotless that spindle is! Based on the bearing numbers you mentioned you have a #84 spindle and the hub part # AKHD-545-35-G-K is correct. Since this its galvanized it's a really great option as it will fight corrosion.
The flexible brake line kits like the part # 18SI-BLKIT is what I would go with. They are just as durable as anything else and a lot easier to install. The brake assemblies # AKFBBRK-35R-D and # AKFBBRK-35L-D... view full answer...