In the Timbren Rear Suspension Enhancement System, part # TIR100, the height of the hollow rubber spring is 3-3/4 inches and the width is 3-3/8 inches. I am including a picture that will show where the measurements are taken on the spring.
I am including a link to the installation instructions on the Timbren suspension. view full answer...
I checked with Westin and they told me that the overall length of the bars # 25-06675 are 62-1/2 inches and the distance between mounting holes is 59-1/2 inches. view full answer...
Yes, the Kat's Heaters Custom Engine Block Heater # KH11615 is sold as shown in the picture. It has a corrosion resistant brass construction. There needs to be clearance both inside the engine block as well as outside. The heating element cannot be in contact with anything inside the engine other than engine coolant or it will burn out. I have attached an image below with the important measurements.
The distance from the edge that seats against the engine block to the far edge of the... view full answer...
I walked out to our warehouse and assembled the Draw-Tite Hitch Cargo Carrier, part # 6502. From the top of the shank to the top edge of the carrier I measured 6-5/8 inches when the carrier is not folded up. Yes, you will be able to open the rear door on your 2004 Isuzu Rodeo when the Draw-Tite Cargo Carrier is attached.
Part # 6502 comes with a hitch pin to secure to your hitch, for added security we have the Trailer Hitch Receiver Lock, part # e98880.
I have linked a picture I took... view full answer...
The Buyers Products Class 4 Service Body Short Hitch Receiver # 3371801053 has a measurement of 1-3/4" from the frame mount to the top of the receiver. It has a bolt hole width range of 28-7/8" to 42-7/8". view full answer...
The Replacement Topwind Black Knob Handle for Ram Jacks # TJPB-HD will measure right at 8 inches from the center of the clamp to the furthest most edge of the handle/knob.
This will also fit all Ram TJB, TJP, and TJDP Series jacks as well as our Round A-Frame Trailer Jack - Topwind - 15" Travel - 5,000 lbs # TJA-5000T-B. view full answer...
I went out and measured the distance between where the legs of the tow bar attach on the Roadmaster Base Plate to Tow Ready Tow Bar Adapter, # RM-025, and the on center measurement is 31 inches.
The distance between the mounting bolt holes that attach to the vehicle base plates is 28-1/2 inches on center.
If you are looking for the overall length it is approximately 34 inches. view full answer...