Expert Answers about Hyundai Santa Fe
- Trailer Wiring Install Harness Recommendation for 2019 Hyundai Santa Fe Ultimate
- There's still a really good chance the trailer wiring install harness for your 2019 Hyundai Santa Fe is present which will allow the Curt T-Connector part # CU94FR to install. This plugs into your Hyundai Santa Fe's factory tow package wiring harness, which is located behind the rear bumper on the driver's side of your vehicle. I attached a picture of where the harness will be plus a link to the install instructions as well.
You might check the pins for voltage with a circuit tester like...
view full answer... - Bolt Size and Thread Pitch of Attachment Hardware for Draw-Tite Class III Hitch # 75471
- The bolts included with the Draw-Tite Class III # 75471 Hitch are Class 10.9. They're 10mm in diameter, 30mm long and have a 1.25 thread pitch.
If you're needing replacement installation hardware, we can supply a replacement hardware kit for you. You'd use part # RHK, and on the product description page you're taken to, you'd input 87414 for the hitch part number and Hidden Hitch as the name of the manufacturer (as shown in the diagram I provided.)
To see other accessories available for...
view full answer... - Thule Replacing Old Square Bar and Podium Foot Pack With SquareBar and Evo Clamp Foot Pack
- The Thule Podium 460 you referenced for old square bars has been discontinued so that is why the expert answers suggest using the Evo Fixpoint Feet # TH49SC for use with the new Thule SquareBar that have a slot in the bottom like the aero style bars. The old Thule square load bars have been discontinued and replaced with the SquareBar like # TH712400.
This bar is not designed for the older wrap around style mount but will use the channel mount like the aero bars were already using....
view full answer... - Replacement Anti Rattle Hitch Pin for Curt Bike Racks
- The anti rattle pin for Curt bike rack # C18087 isn't available as a replacement part. However, it is the same pin as # C22321 for a 2 inch hitch receiver and # F-315 for a 1-1/4 inch.
view full answer... - What 1-1/4" to 2" Shank Adapter is Needed for Older Thule Hitching Post Bike Rack
- It looks like the older 945 version of the Thule Hitching Post was designed for a 2" hitch so you may have a newer version that would require the Adapter # 853-7489. If you can send me some photos of your current bike rack I can help you determine what you have and what adapter will be needed.
The adapter # 853-7292 that you referenced is not a fit for a Thule Hitching Post bike rack.
I have attached a link to a video of the 7489 adapter that you can check out.
view full answer... - Recommended Replacement Rubber Straps for Bike Rack
- We do!
A wide range of bike rack replacement parts are offered for most major brands like Thule, Yakima and Swagman. The linked page will show you all replacement rubber straps and prices.
For example, if you have a Thule rack just click on that brand at the top of the page to see their replacement straps, such as # 852-3006-001 or # 753-3535.
view full answer... - Replacement Hardware for Draw-Tite Max-Frame Trailer Hitch Receiver
- You can get new hardware for your Draw-Tite Max-Frame Trailer Hitch Receiver # 75234 using the Replacement Hardware Kit # RHK. You will need to enter 75234 in the hitch item number field and then add it to your cart.
view full answer... - Replacement Foot Base for Thule Roof Rack on 2014 Hyundai Santa Fe Sport
- The Thule Replacement FootBase # 753-2149 does not work with the Thule fit kit # THKIT4029 which is what fits on your 2014 Hyundai Santa Fe Sport. I confirmed this with my contact at Thule.
If you need a replacement fit kit you can use part # THKIT4029 which is a set of 4 mounting brackets and 4 foot pads. These are not offered singly, only as a set of four.
view full answer... - How to Get a Replacement Bolt for the SportRack Hitch and Cable Lock # A32022
- I spoke to my contact at Sportrack and she informed me that the bolt of the SportRack Hitch and Cable Lock # A32022 is not offered separately. The most practical way for you to get another bolt would be to get the Anti-Rattle Hitch Lock # SR0901 and just use the bolt of the kit.
view full answer... - Weight and Speed Ratings of Trailer Tires
- The very best way to know the correct replacement bearings to use on any trailer is to pull one hub and remove its inner and outer bearings. The part numbers on those bearings are pretty much the most fool-proof way to identify new ones. Since your trailer has been modified it is possible that at some time in the past its spindles, hubs or axles were changed so pulling a hub, although a bit messy, is the very best way to go. You can refer to the photo I linked for you that shows the usual...
view full answer... - Correct Replacement Adjuster Spring for 10" Demco Hydraulic Trailer Brakes
- It sounds like you're looking for an adjuster spring and in which case we do carry this, the Replacement Adjuster Spring for 10" x 2-1/4" Hydraulic Trailer Brakes part # 046-083-01 which works on both Dexter and Demco hydraulic trailer brake assemblies.
view full answer... - Yakima Rail Grab Brass Nut Screw Size and Replacement
- We have the replacement screw you are looking for with the part # Y8880150 which matches up to the nut of the # Y8880279 which is M6.
view full answer... - Trailer Hitch, Wiring, and Brake Controller for 2015 Hyundai Santa Fe
- For your 2015 Hyundai Santa Fe GLS the Draw Tite hitch part # 75776 that you referenced is a confirmed fit and would work well. Then for trailer wiring the correct harness is the part # C56332 that you referenced. And to convert it to a 7-way all you need is the part # ETBC7.
Then for a brake controller the # TK90160 is a great option.
I attached a couple install videos for you to check out as well.
view full answer... - Replacing Damaged Vehicle-Side 4-Pole Connector on Curt Wiring Harness
- Yes, you can replace just the damaged connector on the 4-pole harness on your 2013 Hyundai Santa Fe GLS. Hopkins part # HM48205 includes both vehicle- and trailer-side connectors (giving you a spare for the trailer) and quick-splice connectors. Similar products you might prefer include # C58044 that gives you a 60-inch length and # HM48030 which features an ergonomic-style plug.
You will connect the white, brown, yellow and green wires color for color. I suggest wrapping the splices with...
view full answer... - Firestone Coil-Rite Air Bag Inlet Thread Size
- I'm sorry to hear that you're having issues with your Coil-Rite system. The bag inlet thread on the Coil-Rite # F4170 for your 2014 Hyundai Sante Fe is a 1/4" female NPT fitting. The Firestone Replacement Schrader Valve # F3438 is going to be a better fitting than the fitting that came with the # F4170 and is meant to combat some of the issues that you may be having with the connection.
view full answer... - Sears X Cargo Replacement Key 2806
- Yes, the Sears X-Cargo roof boxes are Thule products and use Thule keys. So the # THKEYN2806 replacement key is what you need.
view full answer... - How to Reduce Suspension Sag When 2017 Hyundai Sante Fe AWD is Towing a Trailer
- I wish we had suspension enhancement that fit your 2017 Hyundai Santa Fe, but at this time we don't have anything that fits. I do have a really great option though that's actually better for trailer towing than suspension enhancement. Instead I would recommend you get a weight distribution system. WD systems are better than suspension enhancement for towing situations as it helps level the tow vehicle by redistributing some of the tongue weight of the trailer up to the front axle. This...
view full answer... - Replacement 7-Way Connector for 2014 Hyundai Santa Fe GLS
- Usually a 7-way connector on a vehicle will be mounted either to a tab that is built in to the hitch or to a cut-out on the vehicle bumper. There are also separate mounting plates that can accept a 7-way connector which you can place as you prefer. One example is # 18138 from Draw-Tite which comes complete with hardware for mounting both the bracket and the 7-way.
The linked video shows installation on a 2005 Santa Fe.
view full answer... - Replacement Mounting Hardware for Karrite Voyager Rooftop Cargo Box
- The Thule Replacement U-Bolt for Thule Sidekick Cargo Box # TH02943 will be the correct fit for your Karrite Voyager Cargo Box. The U-bolt is 4 inches on center and 2 inches deep. Then you can use the Replacement Wingnut for Thule Cargo Boxes # TH04877 to hold the U-bolts inside the carrier.
We also have the Replacement Hardware Kit for Searsbox Cargo Box # TH05603 which will give you the kit with the brackets as well.
view full answer... - How to Tell if Shock Absorber on Titan Model 60 Hydraulic Brake Trailer Coupler Needs Replacement
- According to Dexter Axle, who purchased Titan a few years back there really isn't a definitive method to bench test the shock absorber used in the Titan Model 60 coupler. If you can easily move the shock by hand, it's worn to the point where it should be replaced. It should take a significant amount of force to move the shock.
Should it need replacing, the # T2336200 replacement shock would be the proper replacement.
view full answer...
Go To Results