Expert Answers about GMC Acadia

• Trailer Wiring Harness Options for a 2011 GMC Acadia
• The Replacement Multi-Tow 7-Way and 4 Pole Trailer Connector, # 74682, will fit on your 2011 GMC Acadia if it came with a factory installed 7-way trailer connector at the back of the vehicle. There will be a round plug going into the back of your factory 7-way connector that will mate with the round plug from the Multi-Tow harness. If your vehicle did not come with a factory installed 7-way, then you may have the round connector at the rear of your vehicle tucked in the spare tire or...
  view full answer...


• Photo of Hitch Panel Trimmed on 2020 GMC Acadia With Draw-Tite Hitch
• The Draw-Tite Max-Frame Trailer Hitch Receiver part # 76023 is a great option for a 2020 GMC Acadia. The hitch knockout panel can be re-installed with the hitch in place but it must be trimmed in order to do so. I have attached a photo below which shows what it will look like once trimmed and re-installed. If you were to use the Curt Trailer Hitch Receiver part # C13293, the hitch knockout panel would be re-installed but with no trimming required.
  view full answer...


• Can Longer Ball Mount be Used to Attach Ball Mount Mudflaps on a 2011 GMC Acadia
• Yes, you can use a longer ball mount on your 2011 GMC Acadia Class III hitch to add the mudflaps. The standard ball mount that we show that is recommended for your Acadia is the Convert-A-Ball Ball Mount, part # AMSC2. This ball mount has a 3/4 inch rise or a 2 inch drop. It measures 9-1/2 inches from the center of the hitch pin hole to the center of the ball hole. It has a 10,000-lb gross towing weight capacity and a 2,000-lb tongue weight capacity. A longer ball mount with the same...
  view full answer...


• Does Curt Trailer Wiring Harness Fit 2020 Acadia without Factory Tow Package
• Yes, the Curt wiring harness # C56325 does fit your 2020 GMC Acadia. You can verify by finding the connector behind your Acadia's muffler. If you don't already have a trailer hitch I recommend the Curt # C13293 because it's a much easier install than the other option for your SUV.
  view full answer...


• What Is Location Of Spotter Mirror And Is It A Circle For Item # KS62117G
• I checked with the manufacturer and this K-Source Replacement Side Mirror, Item # KS62117G, has a more rectangular spotter mirror that is in the upper left hand corner. It is a direct replacement for your vehicle's side-view mirror and has a simple bolt-on mounting and plug-in wiring for installation. The "extra" features of the mirror only work if your vehicle already has these functions.
  view full answer...


• Best Hitch Receiver for a 2021 GMC Acadia AT4
• I have a solution for you but the Curt Trailer Hitch item # C13293 you referenced does not fit the AT4 model of the 2021 GMC Acadia. You are going to need the Draw-Tite Hitch item # 76023. This hitch is custom fit and made specifically for the AT4 models. It bolts to your Acadia with included hardware and requires no drilling. I have linked an installation video below. If you need a wiring harness and have the tow package, I recommend the Tekonsha T-One Vehicle Wiring Harness for Factory...
  view full answer...


• Complete Towing Set Up for a 2017 GMC Acadia
• The easiest hitch to install on your 2017 GMC Acadia is going to be the Curt Trailer Hitch Receiver item # C13293. This hitch is custom fit and bolts to your Acadia's frame with included hardware. I have linked an installation video and the instructions for this hitch below so you can see if it is going to be something you are capable of doing at your home. If your Acadia has the factory towing package you will need the T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer...
  view full answer...


• Parts Needed to Flat Tow 2019 GMC Acadia Denali with Adaptive Cruise Control
• I checked with Roadmaster concerning a base plate kit for your 2019 GMC Acadia Denali with adaptive cruise control and there is a fit, the Roadmaster Direct-Connect Base Plate Kit # RM-523189-5, which is one of the parts you will need to flat tow your vehicle, and I'll list each of them for you. - Base Plate Kit: Roadmaster Direct-Connect Base Plate Kit # RM-523189-5 - Tow Bar: Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar w/ LED Lights # RM-676 - Wiring Kit: Roadmaster Diode 7-Wire...
  view full answer...


• Will the Thule Motion 18 Cargo Box Fit a 2011 GMC Acadia with Factory Roof Rack
• I checked with Thule and the Motion 18 cargo box # TH629806 will fit the factory roof rack on your 2011 GMC Acadia. I have linked a video review of this box for you.
  view full answer...


• Will SportRack Roof Cargo Box Fit a 2009 GMC Acadia with Facotry Cross Bars
• The SportRack Roof Cargo Carrier, # SR7018, is a universal fit item designed to fit on cross bars that have a center to center distance between the bars of 23-5/8, 25-7/8, 27-7/8, or 29-7/8 inches. Both Thule and Yakima have direct fit cargo boxes for the factory cross bars on the 2009 GMC Acadia. I have included a link for you to view. You will want to scroll down to the two smaller boxes on the page and choose roof cargo box for direct fit options.
  view full answer...


• Will the Reese Solo Carrier # PS1040100 Fit a 35" long x 35" wide x 6' tall Refrigerator?
• I have a solution for you. Unfortunately, the 35-inch length/width of your refrigerator will not be able to fit on the 32x48 Reese Solo Cargo Carrier for 2" Hitches - Steel - 400 lbs # PS1040100. With that being said, a great solution for transporting your refrigerator is the Detail K2 Mighty Multi Utility Trailer - 6' Long - 1,295 lbs # K2MMT4X6. The K2 trailer has a bed dimension of 72" long x 48" wide x 7-1/2" tall and can hold up to 1,295 pounds. If you decide to go this route, you...
  view full answer...


• Brake Controller for 2017 GMC Acadia with Factory 7-Way
• That we are aware of your 2017 GMC Acadia doesn't have a brake controller port under your dash but we can help install a brake controller since your 2017 Acadia has a factory 7-way. The Curt Echo Mobile # C51180 is compatible with any vehicle that has an active 7-way. All you have to do is sync it to your smart phone and it's ready to tow with.
  view full answer...


• Trailer Hitch Receiver Compatible With AT4 Trim on 2022 GMC Acadia
• For your 2022 GMC Acadia AT4 you will need the Draw-Tite Max-Frame Trailer Hitch Receiver # 76023. Both the Curt # C13293 and our etrailer # e36AR will not fit the AT4 trim. The Draw-Tite is designed to fit as the factory receiver would and hides behind the removable fascia panel. For the wiring I recommend using the wiring from the T-One Vehicle Wiring Harness # 118276 to connect to the factory wiring. Instead of using the included 7-way you can connect the 7- and 4-Pole Trailer Connector...
  view full answer...


• Will Hopkins 7-Way/4-Pole Vehicle Connector HM40975 Fit Curt Wiring Harness C56326
• Curt T-Connector Vehicle Wiring Harness # C56326 consists of a harness with a round U.S. Car connector on the end that connects to the included 7-way socket. Since this is a standardized connector, yes, you can use this Curt harness with the Hopkins combination 7-way/4-pole socket item # HM40975 so that you have both formats of trailer connector active on your Acadia.
  view full answer...


• Swing Away Adapter Compatible With Saris Freedom 4-Bike Rack For 2 Inch Hitches
• I have some good news for you because the Freedom rack does have a compatible swing-away adapter that you can use. So what you will need are the following: - Saris Freedom 4-Bike Platform Rack # SA4414B - Yakima BackSwing Swing Away Hitch Extender for Bike Racks - 2" Hitches # Y02483 These two are compatible because the BackSwing is designed for bike racks with dedicated 2 inch shanks, which the Freedom # SA4414B has, and the BackSwing also has a total load capacity of 250 lbs, which...
  view full answer...


• Floor Mats Fit a 2012 GMC Acadia with 3rd Row Seats Up
• You cannot go wrong with a set of WeathTech rubber semi-custom floor mats. WeatherTech is one of the top floor mat manufacturers on the market when it comes to floor mats. The WeatherTech rubber mats look much better than their PVC mats in my opinion. For your wife's Acadia, I recommend the # WTW68TN for the front and the matching # WTW25TN for the 2nd row and a second set of the # WTW25TN for the 3rd row if she has a 3rd row. These mats are all in tan, but are also available in gray...
  view full answer...


• Adapter Needed To Fit Demco Tow Bar To Roadmaster Base Plates
• To hook the Roadmaster EZ Crossbar Style Base Plate Kit - Removable Arms Item # 523149-1 to a Demco Dominator Non-Binding Tow Bar - Victory Series - RV Mount - 2" Hitch - 7,500lbs Item # DM9511008 the adapter you'll need is the Roadmaster Tow Bar Adapter Item # RM-032.
  view full answer...


• Trailer Hitch That Fits A 2022 GMC Acadia Denali
• The etrailer Trailer Hitch Receiver # e98863 you referenced, does not appear to be a fit for your 2022 GMC Acadia Denali, unfortunately. However, the Draw-Tite Max-Frame # 76023 does fit your 2022 GMC Acadia, and has a maximum towing capacity of 4,500-lbs, and a maximum tongue weight capacity of 675-lbs. You're going to need to check your owner's manual first for your vehicle's maximum towing capacity, and compare the two capacitates between the hitch and the vehicle and use the lowest rating.
  view full answer...


• Are There Any Supplemental Braking Systems That Can Activate Off Of A Trailer Brake Controller
• If you're asking about a supplemental braking system that would activate off of a trailer brake controller in the motorhome then there unfortunately isn't a system currently available that would do this. That being said switching over to either the Demco Stay-IN-Play # SM99251 (hydraulic brakes) or Air Force One # SM99243 (air brakes) depending on the braking type of your new Super C class motorhome would give you a more dependable permanent system. The # SM99251 will need to tap into...
  view full answer...


• Compatibility of the Thule Hullavator on a 2020 GMC Acadia Denali with a Factory GMC Rack
• I have a solution for you, but to answer your question, no the Hullavator will not work with your existing roof rack. We are looking for a roof rack system that the bar hangs over PAST the foot anywhere from 4-6 INCHES. I have included a diagram to illustrate. If you have factory raised rails on your Acadia, I recommend the Thule Evo Raised Rail Foot Pack. We will want to pick your preferred colored bar and then the foot pack. Foot Pack: Part # TH710401 Silver: Part # TH711200 Black:...
  view full answer...