The OVERLOAD error message you are experiencing with your Prodigy P3 part # 90195 is caused by a high current draw from the brake circuit. In other words, there is a short somewhere in your brake output circuit. Typically the problem can be found at the trailer connector, on the brake output circuit on the trailer, or at the wiring connection at the brake magnets if a trailer was connected.
Start by examining the trailer connector on the trailer and the vehicle. Make sure that there is... view full answer...
The 2019 Forest River Rockwood Signature Ultra Lite Fifth Wheel RV 2989BS uses 12 inch brake assemblies so for a set of left and right assemblies you'd want the # AKEBRK-7-SA and you'd be set. This is correct size and capacity and also these assemblies are self-adjusting so you wouldn't have to mess with brake adjustments. view full answer...
Your picture didn't make it through but the Dexter lift kit part # K71-724-02 does fit the Dexter # 11 torsion Torflex axles which have a capacity between 4,100 and 6,000 lbs. Feel free to email me the pictures though and I'll see if I see any reason this wouldn't work for you. view full answer...
We can't get the exact size you mentioned in that brand. Is there a possibility you have a 15 by 5 inch? Did you measure the width including the flange lip? We have that size int the Sendel brand. view full answer...
You'd want to use the non-sag sealant part # 344270341437-1 on vertical applications where you wouldn't want the sealant to drip or run. The # 34427034145-1 is better for horizontal applications as it's self-leveling, but it would run or drip on a vertical application. view full answer...
The best protection you'll get out of a cover for your 2012 Forest River Rockwood Signature Ultra Lite Fifth Wheel is the Adco Olefin HD; you'll need part # AD99ZR for up to a 31' 5th wheel or part # AD49ZR for up to a 34' 5th wheel.
This cover uses the Olefin HD fabric on top for the best protection and then the side panels use a triple layer polypropylene material so the RV is able to breathe under the fabric. This means the RV stays dryer so you don't have moisture building up but it... view full answer...
Yes, you can manually adjust self-adjusting brakes with a spoon like the drum brake spoon # W80630. We've done it here in the office years ago because we weren't sure if it was possible but it is. It is harder to get to the star wheel that adjusts the brake on self adjusting assemblies but it is possible. You'll need to remove the plugs on the back of the assemblies.
For replacement assemblies we do have the set you mentioned of # K23-478-479. view full answer...
For the left hand Axletek assembly for what you are looking for you'd need our part number # AKEBRK-7L-SA and for the right hand side # AKEBRK-7R-SA. view full answer...
A single stage regulator like the Camco Single Stage Propane Regulator part # CAM59013 would still work for you but since you have dual 30 lb propane tanks I would recommend using a dual stage regulator like the Camco Automatic Changeover 2-Stage Propane Regulator part # CAM59005 which has an auto changeover valve that will switch between tanks when one is empty. This system will be much better for your dual propane tank setup. If you do not already have the hose to connect each tank to... view full answer...
The HydraStar Electric Over Hydraulic Actuator # HBA16 referenced in your question is designed for hydraulic disc brakes and it has a maximum output pressure of 1,600 psi. This is the maximum output it will send when applying the brakes in your tow vehicle. It will not shut off, as it simply will not exceed this maximum.
An electric-over hydraulic actuator like this one will trigger the trailer brakes when you apply the brakes in your vehicle, as opposed to when a trailer pushes against... view full answer...
I have an option that may work for you, but the largest lift kit for a torsion axle is 3-1/2".
We offer a few different torsion axle lift kits including the Axle Riser Kit - Single Diamond Torsion Axle - 3-1/2" Lift # LC270682 and the Axle Riser Kit - Single Square Torsion Axle - 3-1/2" Lift # LC382741.
Both of these options offer 3-1/2" lift which is the highest offered, but will only work if the axles on your 2012 Forest River Rockwood Signature Ultra Lite 5th Wheel trailer uses Lippert... view full answer...
That is correct.
You will need to use the Replacement Control Key for Yakima Same Key System # Y8007835 to remove your current lock core, but the lock core will need to be unlocked for the control to be able to remove the core. If the lock core is locked you will need to have a locksmith unlock it for you first.
Once the core is removed you will see the key code stamped in the side of the lock core as shown in the included picture of the # Y8771-A137. For example if your lock core was... view full answer...
According to the research I did on your 2016 Ultra Lite Signature it has 4,000 lb Dexter Torflex torsion axles so the correct lift kit for it would be the part # K71-707-02 which would give it a 2-5/8 inch lift. view full answer...