According to Lippert, the Solera Family Room for 10' RV Awning # LC362225 will only work on Solera, Dometic and Carefree awnings. Unfortunately, this will not fit your Thule awning. view full answer...
The correct slide-topper does depend on the end-to-end measurement, and the 109 inches you got is the necessary info needed for the right fit. What you need for a 109 inch measurement is one of the following, depending on if you want White or Black:
- White: Solera RV Slide-Out Awning - 9'1" Wide - 48" Projection # LCV000163291
- Black: Solera RV Slide-Out Awning - 9'1" Wide - 48" Projection # LCV000168325 view full answer...
For your 2021 Forest River R-Pod RP-193 you'll want the Adco Olefin HD RV Cover # AD47ZR. This cover has zippered panels running down the passenger side of the trailer so that you can access your entry door and cargo compartments without having to remove the cover. The panels can be rolled up and strapped in place if you're needing to make multiple trips in and out of the trailer. view full answer...
While we don't have just the grey pad of the Yakima Raptor Roof Mounted Bike Rack we do have the entire jaw pad assembly with the part # 8820182 instead which would be your best option. view full answer...
You could use bigger tires, but larger tires and wheels would mean less clearance to the trailer frame and fenders. For that reason I think axle risers are the better option.
The Torflex Lift Kit - Single Axle - 2-5/8" Lift # K71-707-01 would add 2 5/8" lift to your 2011 Forest River R-Pod Travel Trailer. You will need to check the sticker on the axle to ensure it is a Dexter Torsion axle. view full answer...
The Go Power Portable Solar System with Digital Solar Controller part # 34282730 comes with everything needed to plug into an R-Pod, there will be no separate cables or adapters needed if you have the pre-wired solar port. view full answer...
The Adco # 290-52240 AquaShed features three zippers on the passenger side, which will allow access to either a door toward the front of the camper or a door located in the rear. I've confirmed this with Adco. Having 3 zippers creates two panels, which will allow access to the front half, the rear half, or most of the full side of the camper if both are unzipped. view full answer...
The Torflex Lift Kit # K71-724-02 is designed to be used with #11 Dexter Torsion axles. To verify this is what you have under your 2020 Forest River R-Pod RP195 you can verify with the label on the axle tube or measure the bolt pattern for the axles. The bolts for the axle connection to the frame will be spaced 9" on center. This will give you a 2-7/8" lift for your R-Pod. If you have a different axle or measurement please let me know so I can confirm the correct kit for you. view full answer...
The covers for your 2016 Forest River R-Pod 177 are designed to take into account the different accessories that are on your roof, including your air conditioner and antenna, which will be covered and still be the proper length.
For your 2016 RP-177 the best cover is the Adco SFS AquaShed Cover for Travel Trailer # 290-52239. view full answer...
Yes the Lippert Components Axle Riser Kit for Single Diamond Torsion Axle part # LC270682 has been confirmed to work on several R-Pod campers. The one thing to ensure is that the axle is the Diamond type. Meaning the torsion axle looks like a diamond under the camper rather than a flat square.
See the attached photo for an example of what the Diamond axle looks like. view full answer...
Yes you could cover the Valterra Self-Regulating Heating Cable for RV Plumbing # W01-1573 with reflectix insulation if you wanted to hold more of the heat to where you install it. view full answer...
Yes, RV storage covers like the Classic Accessories PolyPro III Deluxe RV Cover for R-Pod Trailers # CA80-197-171001-00 do take into account for AC units and other accessories being on the roof. I was actually just looking at a similar cover from Classic Accessories that we used on the HYK trailer we have here and it was surprisingly thicker than I was expecting.
This specific cover is for trailers measuring 17' in length from the front of the rear bumper to the tip of the trailer tongue.... view full answer...
Thank you for the all the info, I was able to determine that you have a Rhino Box bolt pattern so the correct replacement would be the Curt Flex Air 5th Wheel Pin Box # LC65VR for your 2023 Grand Design Momentum 381MS. The Rhino box is quite a disappointment to most trailer owners so this new Flex Air will sit a bit lower and should help raise the nose of your trailer up to ride more level. view full answer...
To cover your 2020 R Pod 190 for the winter you are going to want the Adco Olefin HD RV Cover for Travel Trailers up to 18' item # AD37ZR.
This cover is designed to protect your trailer against every season. No matter what part of the country you are storing your R Pod trailer this cover will protect it. From snow to heavy exposure to sun and wind the Adco cover extends the life of your trailer. The heavy weighted straps and elastic corners provide a tight fit and the zippered panels on... view full answer...
Yes, you can remove the bracket bolts off of the Scissor Stabilizer Jack - 18-3/4" Travel - 2,500lbs - Qty 1 # TJSC-24 and attach it to the brackets you already have on your camper. I actually end up recommending doing this quite a bit because RV manufacturers love to use odd sizes and most people would prefer to not add more holes in their campers when they can just reuse their current bolt holes. view full answer...
Lippert's 4,400 lb axles like what you have use the same bearings as 3,500 lb axles so the correct replacement bearing kit is the following:
- Bearing Kit # BK2-100 view full answer...
The 2017 Forest River R-Pod could use either the Axle Riser Kit - Single Diamond Torsion Axle part # LC270682 or Axle Riser Kit - Single Square Torsion Axle part # LC382741. It all comes down to what was installed at the factory which could have been either. Unfortunately, we don't have a way to look up exactly what you have so you'd need to physically check for yourself whether you have a diamond or square axle. view full answer...
Since your unit is hardwired you would have to cut the connector off of the Advent Air Replacement RV Air Conditioner # ACDOM135 in order to hardwire it into your system. Doing this will void your manufacturer warranty so I do not recommend it and instead recommend just replacing the system entirely with one like the Furrion Chill HE RV Air Conditioner System - Manual - 13,500 Btu - White # FR52PR or # FR95PV for wall mounted thermostat.
If you don't care about the warranty and are will... view full answer...
We do have a cover that fits your 2017 R-Pod RP-178 and has the zipper in the proper place to give you access to the entry door. The cover that you need is from Classic Accessories and is the following part number:
- Classic Accessories Deluxe PolyPro III HD Cover for R-Pod Trailer # CA80200
I have added a photo below which shows where the door access is with the # CA80200 on your R-Pod. view full answer...