I went and measured the Baggage Door Catches # 37210254 and the overall dimensions of these are 2.6" long and 0.993" wide. The mounting screws are approximately 0.6" apart (center on center). view full answer...
The length of the retractor spring in the kit # K71-422-00 is 7-3/4" from end to end.
Attached is a diagram showing these measurements for you to check out as well. view full answer...
You may not actually have to replace your axles. If they are bent up towards the floor of your trailer (see attached picture) then that is normal and they will level out as you add a load. If they are bent downwards towards the ground then they are definitely in need of a replacement.
We don't have access to all of Dexter's information so the Dexter Axle would need to be contacted themselves in regards to the part number, but if you have a tape measurer handy there are a few places you... view full answer...
The Tire Grip Vehicle Traction Recovery Track for Snow, Mud, and Sand # 288-07411 actually doesn't have a weight rating so it will work great for a heavy duty truck like your F-550 with the service bed. view full answer...
Trailer couplers are not rated for tongue weight capacity. They are rated for Gross trailer weight, as long as the gross trailer weight is within the capacity of the coupler, the coupler is installed properly and the trailer is designed properly, the coupler will handle the tongue weight of the trailer. Proper installation of the coupler is the key to it handling the weight it is rated for and the manufacturers directions should be followed explicitly.
For a 16k trailer the part # T4855300... view full answer...
Couplers and hitch balls are rated only for gross trailer weights. But the common total trailer weight to tongue weight ratio that is used is 10 percent.
So the 30k rated hitch ball part # BWHB94004 would have a 3,000 lb tongue weight rating easily. view full answer...
The distance from the toilet seat, to the hump on the back of the Dometic 321 Full-Timer RV Toilet # DOM99FR is approximately 5".
The center of the flange bolts to the edge of the toilet is 16.9", and the entire length from the back flange to the front of the toilet seat is 22".
Attached is a diagram for you to check out as well. view full answer...
The width of the step refers to the depth of the platform and not how wide the platform is. From side to side the platform of the # CARR108221 measures 7 inches and the depth measures 3-1/2 inches. view full answer...
I contacted B&W direct here and they do not have a direct bolt up kit for the 2017 Ford F-550 Cab and Chassis truck as they have a much narrower frame of 34" and they normally recommend that you use one of the center sections like the B&W Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRC800 and fabricate the mounting system to the frame of the Cab and Chassis.
Included is a video overview of this solution for your reference. view full answer...
I just went out to the warehouse and measured the Curt Trailer Hitch Receiver item # C15845. I have attached a couple of diagrams with the dimensions of this hitch on them.
From the center of the back bolt to the front of the receiver is 26"
The crossbeam is 4" X 4"
From the center of the back bolt to the crossbeam is 18" rear 22" front view full answer...
You are going to need the 7-Way Trailer Plug Extension # C86DR to go with the Hopkins Endurance Quick-Install 7-Way Trailer Connector # HM55FR on your 2022 Ford F-550 cab and chassis. The included pigtail with the Hopkins is only 1' so the additional 20" you get with the extension will give you the 2' length you need to your service bed. Be sure to use Dielectric Grease # 11755 inside these connectors. view full answer...