Great question!
Although a 5th wheel hitch rated for 20K can tow up to 20K we highly recommend using a 5th wheel hitch that is rated about 1K - 2K over the GVWR of your 5th wheel trailer. This gives you a safety margin and will help keep your hitch from prematurely wearing down from normal use. The only time you would be able to safely use the 20K hitch is if you didn't load your trailer up to the 20K capacity.
If your toy hauler is 20K then I recommend going with either the B&W Companion... view full answer...
The Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs # UF17-943010 has a measurement of 13-1/2 inches from the top of the highest tab to the top of the middle tab. Then from the top of the highest tab to the top of the bottom tab is 19-1/8 inches. I measured these for you in our warehouse and have attached a photo to assist. view full answer...
On the Morryde pin box you referenced # MR24VR that you referenced it measures 25-5/8 inches from the center of the king pin back to the rear mounting holes. Since the rear mounting holes are right at about an inch from the rear of the pin box you'd have the clearance you are needing since you said you needed less than 30 inches. view full answer...
I checked with Timbren and they got me the dimensions you are looking for. The # TFRSDD is 9-3/16 total height and 8-3/16 without the spacer and the # TFRSDPA is 6-9/16 inch total height. view full answer...
The B and W Companion Hitch for Ford OEM rail kits part # BWRVK3300 does fit the rail kit of your 2021 Ford F-450. I'd suspect you might have to lower the hitch head height but it really just depends. I doubt your 350's suspension was sagging much with the weight of the trailer on the hitch but the 450 would sag even less so it would most likely sit taller. But you also would want to measure the height from the top of the truck bed to the ground for both trucks and compare the heights there... view full answer...
The Surco Universal Exterior RV Ladder # SP502L is 84-1/2" long (tall). I have also included a couple pictures detailing some more of the measurements. If there is a specific measurement you were wanting, please let me know.
We also have the Stromberg Carlson RV Exterior Ladder # LA-401 which is 99-1/2" long (tall) and can but cut to fit your needs. view full answer...
The Air Lift Air Spring # AL50236 has what they call a design height of 7". There are 3 different height bags (5.5", 6" and 7") and they are determined by the number stamped on the side of the bag.
The bags that come in the Air Lift LoadLifter 5000 # AL57347 that is made to fit your 2008 Ford F-450 are 6" design height.
Air Lift does produce Spacers in a variety of heights to adjust for trucks that may have lift kit installed.
2" Spacer # AL52420
4" Spacer # AL52440
6" Spacer # AL52420 view full answer...
I went out to the warehouse to take some measurements for you and made a diagram for you to check out with those measurements of the Curt Front Mount Trailer Hitch Receiver # C31078 for your 2017 Ford F-450.
From outside to outside at the widest point the hitch measures 39-9/16" and from outside to outside of its brackets measures 29-15/16". It is also approximately 12-1/2" deep overall and the receiver juts out approximately 7" from the bar. view full answer...
The Curt Hitch Cargo Carrier 24x60 # C18152 that you referenced should work well to transport your tool box as long as it and your tools do not exceed the weight capacity of cargo carrier. This carrier has a weight capacity of 500 lbs.
The inside dimensions of this carrier are 24 inches by 60 inches which would easily accommodate your tool box that is 19-1/4 inches by 56 inches even with its rounded corners. view full answer...
The B and W Companion hitch part # BWRVK3305 that you referenced weighs 159 lbs. The head is easily removed to make the install and removal of the hitch easier as well since it splits the weight up. The head weighs 71 lbs. view full answer...
The install kit for a 24k Signature Series 5th Wheel on 2008 Ford F-450 Super Duty is actually the same; Signature Series Fifth Wheel Hitch Installation Kit, # 30073. However, installation kit 30073 is only rated for 18,000 pounds.
The 24k hitch can handle 24,000 pounds but in order to achieve that capacity, the hitch will have to be custom installed by a qualified technician. Kit 30073 will not fit Cab and Chassis models.
If you have a Cab and Chassis F-450 with 34 inch wide frame rails,... view full answer...
The outer tube of the Bulldog # BD0289800300 Gooseneck Trailer Coupler measures 20 inches long as shown in the diagram that Bulldog provided for me. The outer tube is 4-1/2 inches square. The inner tube is 4 inches square and measures 31 inches long.
If you click the provided link, you can see a product description video featuring the coupler. view full answer...
The cannister dimensions of Retrax PRO MX tonneau covers like the part # RT80384 that you referenced are 11-5/8 inches tall by 13-3/4 inches front to back. view full answer...
The 2 gallon air tank that comes with the Air Command II Compressor System # F2592 is Firestone part 9420 which measures 14-1/2" long and 8" tall (see attached picture).
I have also attached an installation video of this kit on a 2017 Ford E-Series Cutaway that you can use as a reference. view full answer...
The length of the Replacement Mud Flap for Enkay Rock Tamers HD Adjustable Mud Flap System # ERTO22 is 24-1/8 inches and the width is 23-7/8 inches. view full answer...
We do have the covers for the pucks as well as the gooseneck hole for the Ford puck system. You will need the following:
- Two of the Replacement Puck Plug Covers # 58199
- Rubber Hole Cover # RP30136 view full answer...
There is not a weight rating for the Curt Custom Fifth Wheel Installation Kit # C22BR. The rails are rated for use with any 5th wheel hitch that will fit into the Industry Standard Rails. Some of which can be rated for 30K or more.
Your towing setup is only as strong as the weakest component. So the limiting factor here will be either the weight capacity of your fifth wheel hitch, or the towing capacity of your truck. Whichever is lower. view full answer...
By far the best gooseneck hitch available for your 2013 Ford F-450 is the B&W Turnoverball Underbed System item # BWGNRK1111. This system is custom fit and installs in existing holes in your truck's frame. B&W makes some of the best towing equipment on the market and it is all made in the USA.
The B&W Turnoverball Underbed System item # BWGNRK1111 has a massive 30,000 lbs capacity. It includes a 2-5/16" gooseneck ball that can store inside the square receiver. You will have full access... view full answer...
Most likely the Reese M5 5th Wheel Trailer Hitch # RP68FR was tested to that capacity and they just never went higher since the 6,400lb capacity is above the pin weight capacity of the truck that would use it. It's very common practice to just hit the maximum for the truck and stop testing. view full answer...
I reached out to Firestone, who was able to give me the heights of the various 7 inch diameter 2-gallon, 3-gallon, and 5-gallon air tanks, measured from the bottom of the mounting brackets to the top of the air tank.
They said that each of these 7 inch diameter tanks measured 8 inches tall:
- 2 Gallon: Firestone Air Tank (2) 1/4 NPT Ports # F9126
- 3 Gallon: Firestone Air Tank (3) 1/4 NPT Ports, (2) 1/8 NPT Ports # F9245
- 3 Gallon: Firestone Air Tank (2) 3/8 NPT Ports # F9229
- 5 Gallon:... view full answer...