We don't have anything with those numbers, so to find a replacement taillight for your RV you will need to measure your current tail light and find the one that most closely matches your measurement.
For example, the LED Trailer Tail Light # DG52721PB is 11" long x 8" tall x 1-1/4" deep. I have added a link below to our entire selection of tail lights which you can filter by size. view full answer...
You would not actually need a connector because the Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens # OPT78FR comes with its own connector, a Delphi plug, already attached.
If your trailer doesn't have a Delphi connector for this light to plug into, there is actually the same exact light available, but with the standard 3-wire pigtail that you would just splice in:
- Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible... view full answer...
The Solera 18V Power RV Awning # LC730523 is rechargeable, and includes a 110V charger kit . The battery is able to run 22-25 times before needing to charged again. Unfortunately adding an LED light is not possible with this awning. Adding an LED kit is based on the awning fabric.
To add an LED light you'd need to upgrade your awning arms with a conversion kit like the Solera Smart Arm 12V Power RV Awning Conversion Kit # LC759516. From here, you can add an LED light # LC674282. view full answer...
The Replacement Lens for Omega RV Dome Light with Switch # 328-89-255 is opaque in most areas of the lens, there is a small area that can be seen through more clearly. I have attached a picture of this lens in a hand which shows how much can be seen through.
The Replacement Lens for Omega RV Dome Light with Switch # 328-89-255 is the correct lens for the Omega RV Dome Light with Switch # 328-001-901XPW and the Omega RV Double Dome Light with Switch # 328-001-902XPW lights. view full answer...
The Roadmaster Rollaway Trailer Hitch Protector, # RM-050 will most likely work with your hitch but you will need to take a few measurements for confirmation. You will need to measure on the center of the hitch pin hole of your Gen Y hitch to the face of the hitch. We are needing 2-7/16 inches. This designed for the support bar to seat firmly against the bottom of the hitch. If you have a gap, adjustments can be made but most hitches meet this measurement. Please see the attached product... view full answer...
Go To Results