We do indeed offer fan-powered coolers that can be used for either engine oil or transmission fluid. In really rough slow-speed off-road conditions a passive cooler like Derale # D13503 may not get enough air flow through it for it to do its job. In such cases a fan-powered cooler is definitely the way to go. Coolers are not fluid-specific, meaning that any given cooler can be used for engine oil or transmission fluid. The are not vehicle-specific either.
We offer both single-path and... view full answer...
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached a help article on determining tongue weight for you to check out as well. You will want the loaded tongue weight of your setup to fall right in the middle of the tongue weight range of the system you use.
The tongue weight of a trailer is... view full answer...
I don't offer the Kenda ST225/75-15 Load Range D with an unpainted wheel, about as close as we can come to that is either the # AM32666 which is the same tire on a galvanized rim with a 6 on 5-1/2 inch bolt pattern or the Taskmaster # TA62FR 225/75-15 Load Range D Tire mounted on a silver powder coated mod wheel with a 6 on 5-1/2 inch bolt pattern.
If you wanted the wheel to match your existing wheels, you could use the # AM32673 wheel/tire combo you'd looked at and paint the wheel silver.
I've... view full answer...
9-pin connectors are rare these days. We do still offer vehicle and trailer side connectors of this type, such as # PK12907 and # PK12906, but we do not have any adapters that can convert your truck's 7-way blade-style RV connector to a 9-pole round pin type. A 9-pole connector like # PK12906 has two extra circuits (auxiliary on the gray wire and reefer on the orange) that would not be supported if fed by a 7-way socket. You'll want to swap out the truck connector using part # PK12907. view full answer...
Reese doesn't offer an adapter like the Curt # C16210 that would work with your sliding hitch, but there is an alternative that would work for you.
Reese offers the Hi-Rise 5th Wheel Trailer Hitch # 9480-5W that would be compatible with your Hide-A-Goose gooseneck hitch. This is a non-sliding hitch that would only be compatible with a long bed truck. view full answer...
There sure is! The Roadmaster Rear Ant-Sway Bar you referred to, part # RM-1109-167 is a fit for your 2008 Silverado 1500. The anti-sway bar is compatible with your Air Lift air bag suspension. If your truck is lifted, you'll need the extended end-links, part # RM-590045-00.
If you'd care to see the installation instructions, or other items that are available for your truck, please click the provided links. view full answer...
If properly equipped and the 5th wheel does not exceed the maximum towing capacity for the vehicle. I suggest you consult the vehicle specific owners manual for towing specs first because Chevy has determined that fifth wheel and gooseneck trailers should not be towed with some models of the 2005 Silverado. There is a difference between can tow something and towing something safely. For a 2005 Chevrolet Silverado 1500 HD with 6-1/2 foot bed you will need a slider type hitch. You will... view full answer...
We do offer a stainless-steel hitch lock suitable for the 2-1/2-inch Class V factory-installed hitch on your 2011 Silverado. TowReady lock # TR63253 features a stainless-steel pin and a chrome-plated lock assembly. The linked video will help to illustrate its features and operation. This lock has a 3-1/2-inch-wide center span and includes 2 keys.
The lock you referenced, etrailer.com part # e98881, has a center span of 3-5/8-inches and will fit a Class V 2-1/2-inch hitch receiver, but... view full answer...
If your 2001 Chevy Silverado is a Light Duty model we have a couple of front mount hitches that will fit the Curt # 31302.
If it was a 1500 Heavy Duty model then you would use # 65028 or # 31108.
The differences between the LD and HD models of the 1500 require different hitches for each. view full answer...
The pull wire or fish wire included in hardware kit # RP56001F is for the 5/8 inch bolts in the kit so for a 5/8 pull wire you can use # C58430. view full answer...
The Hopkins Smart Hitch Backup Camera and Hitch Aligner System # HM50002 does not have a larger monitor available other than the 3.5 inch. They only offer a smaller monitor with a 2.5 inch screen in # HM60195VA. view full answer...
In order to just purchase the head and head support assembly for the Pro Series 5th Wheel Trailer Hitch with Square Tube Slider, # PS30121, you would need to order the Replacement Double Pivot 20K Head and Head Support, # 30118.
As long as your currently installed slide legs match those on # PS30121, this head support will match up and work for you. view full answer...
The B&W Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches # BWRVK2500 can be split up between the brackets and the rails. The B&W Custom Mounting Brackets for Patriot 5th Wheel Above Bed Base Rails # BWRVR2500 are available separately from the base rails # BWRVR3210. You will want to use only custom brackets and rails from the same manufacturer to confirm fit, so if you don't know the manufacturer, then I recommend purchasing the complete kit to ensure they will fit... view full answer...
For the brackets and hardware only from Curt 5th wheel installation kit # C16418-204 you will need to use # C16418. I have linked a video showing all of the included parts. I have also linked a video showing an example installation for you. view full answer...
Westin does not offer tube step adapter kits for lifted trucks like your 2004 Chevrolet Silverado. However, you can still install tube steps like # 23-1680 on your extended cab Silverado that has a 3-inch body lift; the steps will just be 3-inches higher than usual relative to the ground since they mount to the rocker panels. view full answer...
The K Source Custom Towing Mirrors, item # KS62049-50G, for the 2006 Chevrolet Silverado are manual mirrors. If you want towing mirrors that are electric adjustable we have the K-Source Custom Extendable Towing Mirrors - Electric with Driver Side Heat - Textured Black - Item # KS62075-76GE.
All of these mirrors extend and retract manually. view full answer...
Currently the only front receiver hitch's available have a 500lb maximum vertical load.
The Curt Front Mount Trailer Hitch Receiver # 31108 has a maximum 500lb vertical load, 5,000lb trailer weight and 9,000lb line pull rating.
Draw-Tite Front Mount Trailer Hitch Receiver # 65028 has a maximum 500lb vertical load, 5,000lb trailer weight and 9,000lb line pull rating. view full answer...
K-Source offers the # KS62075-76G Custom Extendable Towing Mirrors that have power adjustable glass, turn signals and a heated mirror surface. The mirrors CAN fold up against the side of the truck and are extendable, but they do so manually. None of the mirrors we offer have a power fold or extend feature.
If you click the provided link, you can view an install video. view full answer...
It sounds like you're looking for a Type 1 ACME x 1/4" male NPT connector, like the one that is included with # CAM59863. If all you need is the black, low pressure propane cylinder connector, you can use # 204024-MBS. This will connect between the regulator # CAM59013 and cylinder, just like you wanted. view full answer...