We do have a couple replacement AC shrouds available that may work to replace the unit on your Coleman Mach AC. The closest option we have available to the measurements you provided is the MaxxAir TuffMaxx Replacement Shroud - White # MA00-325001. This particular shroud is actually designed to work with Coleman Mach 1, Mach 3, and Mach 15 models
Its base measurements are 41-5/8 inches long, 28-3/4 inches wide, and 12-5/8 inches tall. I have attached an image with these and a few additional... view full answer...
Yes. Thule, the manufacturer of the Gateway trunk mount bike rack # TH88VR, has done testing and determined that it does fit the 2015 Buick Encore! I have linked a video featuring this bike rack for you.
If you will be carrying any bikes that do not have a top frame bar that goes straight across (like a typical men's bike would) then I recommend using bike adapter bar # 64005. This will allow you to carry those bikes more level and will provide better ground clearance. I have linked a... view full answer...
According to Curt, the manufacturer of the Curt Class I Trailer Hitch, # C11527, this trailer hitch will fit the 2013 and 2014 Buick Encore. Buick did not make any changes in the mounting points for the trailer hitch on the 2014 models. view full answer...
Thanks for the photo, and we have been told previously by Yakima that you can indeed change out the lock cores on the older cargo boxes with the SKS system, so you can use the Yakima Same Key System (SKS) Lock Cores # Y07202. view full answer...
To add a set of crossbars to your 2021 Buick Encore you will need the following parts:
Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 49" Long - Qty 2 item # RRVA126B-2
Rhino-Rack SRB Legs for Vortex Aero Crossbars - Flush Factory Side Rails - Qty 4 item # RRSX040
This aero bar roof rack system has a 165 lbs capacity. The included locks will help prevent theft. The rubberized vortex strips in the top channels dramatically reduce drag and wind noise.
I have linked an installation... view full answer...
Yes, you would want to use an anti-rattle for the 1-1/4 inch portion of the adapter. For that the Hitch part # C11257 would work well. It uses a U-bolt to hold the adapter tight to the hitch tube. view full answer...
We do have hitches available for the 2015 Buick Encore with Class I Curt hitch part # C11527. I did take a look at your owner's manual and there is not a towing capacity listed because Buick does not recommend using this vehicle to tow a trailer because it is not designed to handle the extra weight.
If you still plan on doing some towing, you will need a wiring harness to illuminate the trailer lights with part # 118588 and a 1-1/4" hitch compatible ball mount. You will need to do some... view full answer...
I am not sure which aftermarket rails you might be referring to. If you have flush rails running front to back and no crossbars then you will first need to install crossbars such as Rhino-Rack Vortex Aero Crossbars # RRVA126B-2 along with Legs # RRSX040. Then you can add a roof basket like Thule Canyon XT Roof Cargo Basket - Steel - 49" x 40" x 6" - 150 lbs # TH859XT.
The Curt Roof Mounted Cargo Basket - 41-1/2" Long x 37" Wide x 4" Deep # C18115 you were looking at is not able to fit... view full answer...
We sure do. Thule manufactured the Voyager XL roof mounted cargo box, so their replacement keys are compatible. You'll need replacement # THKEYN2862. view full answer...
The Thule Passage 2 Bike Carrier # TH910XT is compatible with your 2019 Buick Encore with the rear hatch.
Just like with any other trunk mount rack you will need to remove the bikes and the bike rack prior to opening up your rear hatch. Reason being that the hooks used to mount the bike rack can possibly damage your vehicle, the straps could get loose, plus the rear hatch wasn't designed to hold that kind of weight so it could cause the hatch to close unexpectantly on you.
The only way... view full answer...
Thank you for the picture of your crossbars. The interior width of the Thule SUP and Surfboard Pads # TH846000 you referenced are 11 1/4" with the pad opened. They fit most aero, elliptical and factory cross bars.
These give you 2 more inches than compared to your current ones, and by the looks of your cross bars these will work great. I also included a photo a short review video for you to check out. view full answer...
I am sorry to hear about the trailer hitch you had on your 2015 Encore. I am curious though. Can you tell me what you had on the hitch at the time?
If the hitch was installed properly and you were not carrying something that exceeded the weight capacity, the hitch should not have bent like that and certainly should not have hit the ground.
The Curt hitch # C11527 is the only hitch that we carry for your Encore at this time.
The Curt hitch # C11527 requires that all non-trailer loads... view full answer...
Yes, the Thule UpRide Rooftop Bike Carrier # TH599000 will work on the factory crossbars of your 2019 Buick Encore, which has a crossbar spread of 27-1/2 inches.
You should be able to open up your rear hatch door without any problems, but you can take a quick measurement just to be sure. With your rear hatch open, measure 49-1/2 inches back (toward the rear of the vehicle) from the front edge of the front crossbar on your Enclave. This is the space that will be occupied by the Canyon's... view full answer...
The highest class rating for a trailer hitch that fits your 2016 Buick Encore is the Class I Curt # C11527 with the 1-1/4" receiver. While this isn't a Class III hitch with a 2" receiver, it will still do a great job at helping you to transport cargo or up to 2 bikes. If you let me know what you're needing the trailer hitch for I can help you choose any other parts you're needing.
I have attached an installation video of the Curt on a 20195 Encore that you can check out.
The Curt # 13424... view full answer...
First, for a trailer hitch, for your 2014 Buick Encore is the Curt # C11527. This is a Class I hitch so it will be compatible with some hitch mounted cargo carriers. It will not work with the Yakima EXO # Y62VR because this carrier requires a class III hitch or above.
There are no enclosed carriers that will work with a class I hitch. Instead, I recommend the 19 X 47 flat Curt Cargo Carrier # C18110 You will need to determine the weight capacity of your vehicle and make sure that the... view full answer...
The Curt Trailer Hitch Receiver # C11527 on your 2018 Buick Encore is a class I hitch. Only the the Hollywood Racks Trail Rider # HR200Z will be compatible with your hitch. The Curt # C18085 is a very similar rack in almost every way except it is only rated for class II and class II hitches so it will not work for you.
The # HR200Z is a good choice and can secure up to 2 bikes that weigh 45 lbs each by the frame with its hooks and it measures 12-1/2" from the center of the hitch pin... view full answer...
Adding a hitch to any vehicle is a great addition and gives you plenty of options for anything you may be transporting. Although there is not an option for a hidden hitch for your vehicle at this time, I do suggest the Curt Class I Trailer Hitch Receiver Item # C11527. Whether you are looking to add accessories, or tow a small trailer, this 1-1/4" hitch is more than capable. It provides a tongue weight rating of 200 pounds along with a maximum gross trailer weight of 2,000 pounds. When... view full answer...
Yes, the trailer hitch # C11527 is a confirmed fit for the 2015 Buick Encore. If you plan on doing some towing the correct ball mount is # 36071 and you can use 1-7/8 inch ball # 19256 or 2 inch ball # 19258. For trailer wiring you can use # 118588.
If you are not towing, and using it for a bike rack or a cargo carrier, you will also need the stabilizer strap # 18050. view full answer...
The replacement mounting hardware for the Draw-Tite Trailer Hitch # 36554 on your 2018 Buick Encore can be obtained with part # RHK. Once on the product page simply type the hitch model number (36554) inside the text box provided and select "Draw-Tite" from the manufacturer drop-down menu. We will then send out the full hardware kit for this particular hitch.
Keep in mind though that the hardware should be included if you purchased the hitch new. Sometimes the bag can be pretty well hidden... view full answer...
The Thule Sidekick Roof Mounted Cargo Carrier Box part # TH78GC has inside dimensions of 50" long x 23" wide. Therefore, if the object in question did not exceed this it would fit just fine inside. If you wanted to free space up inside the box you could also use the Malone Paddle Carrier part # MPG121 which is designed specially for paddles and other longer objects. view full answer...