Replacement Lift Cylinder for Western Hydraulic Snow Plow - 11" Stroke - Double Acting

Video Transcript for SAM Snow Plow Parts - Snow Plow Replacement Parts - 3371304204 Review

Speaker 1: Today we're going to take a look at the replacement two inch by 11 inch double acting angle cylinder for the Western snow plows. This part will replace the double acting angle cylinder on a Western snow plow, it does replace the Western part number 56750. The bore size on this is two inches. The diameter of the rod is one and a half inches. Just to show you, we'll put a ruler on that, there's your one and a half inch diameter on the rod. The rod itself is 11 inches long so it gives you an 11 inch stroke with a double acting lift cylinder.

The base on this, the diameter seems right at two inches. The pin size, which are these holes here that the pins will go through, the diameter on those openings are going to be right at one inch in diameter.Now the center to center dimension when it's retracted, like the position it is in now, from the center of this pin hole to the center of this one is 18 1/4 inches. When this rod is extended out, it will be 29 1/4 inches. The port type, you can see there is dual ports here. They are size number 6, SAE.

And the location on these are 90 degrees. But that should do it for the review on the replacement two inch by 11 inch double acting angle cylinder for the Western snow plows.